User manual NEFF T23S36N0GB

[. . . ] en Operating instructions Neff GmbH Carl-Wery-Straße 34 81739 München Cod. 9000413914 F www. neff-international. com Table of contents Safety precautions. 16 Environmentally-friendly waste management . 16 3 Dear customer, Congratulations on your choice and thank you for purchasing one of our appliances. [. . . ] Press the chosen burner control knob and turn it anticlockwise to the required setting. Use any type of lighter or flame (cigarette lighter, matches, etc. ) and bring it close to the burner. Switching on automatically If your hob can be switched on automatically (ignition sparkers): 1. Press the chosen burner control knob and turn it anticlockwise to the maximum power setting. While the control knob is still pressed down, sparks are produced on all burners. The flame ignites (it is no longer necessary to press down the control knob). Turn the control knob to the required setting. If it does not come on, turn the control knob to the off setting and repeat the steps above. This time, press and hold the control knob for longer (up to 10 seconds). If after 15 seconds the flame does not ignite, switch off the burner and open a nearby window or door. Wait at least one minute before trying to switch the burner on. 8 Safety system Depending on the model, your hob may have a safety system (thermocouple) that prevents the flow of gas if the burners accidentally switch off. To ensure that this device is active, switch on the burner as usual and, without releasing the control knob, press and hold it down firmly for 4 seconds after lighting the flame. Ignition sparker Thermocouple Switching off a burner Power levels Setting Control knob off Maximum capacity or aperture and electricity on Minimum capacity or aperture Turn the corresponding control knob clockwise to the 0 setting. The progressive control knobs can be used to control the power needed, from minimum to maximum power. High flame Low flame For dual double-flame burners, the inner and outer flames can be controlled separately. The available power levels are as follows: Inner and outer flame on full power. Outer flame on minimum, inner flame on full power. Inner flame on full power. 9 Inner flame on minimum power. Warnings It is normal to hear a slight whistling noise while the burner is operating. When it is first used, it is normal for the burner to give off odours; this does not pose any risk and does not indicate a malfunction; they will disappear in time. A few seconds after the burner is switched off, a sound (thud) will be produced. This is not a fault - this means that the safety device is no longer operating. If the ignition sparkers are dirty they will not light properly. Clean them periodically using a small non-wire brush. Bear in mind that the ignition sparkers must not suffer any serious impacts. This is caused by the presence of dust in the atmosphere, spilt liquids, etc. The kitchen will become hot and humid when this gas appliance is used. You must therefore ensure that the kitchen is well ventilated: either keep the natural ventilation apertures open, or install a ventilation system (extractor hood). [. . . ] The automatic safety switch or circuit breaker has tripped. There may be food or cleaning products stuck between the ignition sparkers and the burners. The burner covers are not correctly positioned. The appliance is not earthed, is not correctly connected or the earth wire is faulty. [. . . ]