User manual NEFF T2766NOAU

[. . . ] All burners are fitted with electronic spark ignition and flame failure device. The wok burner is supplied with a supplementary wire pan support for smaller pans. An additional wire pan support is supplied to fit over the boiling burner pan supports to support small vessels such as a coffee pot. The cooktop's data plate is accessible even with the cooktop fully installed. [. . . ] Do not place a pan on one side of a burner, as it could tip over. Never place pans directly on top of the burners. Do not use large pots or heavy weights which can bend the pan support or deflect the flame onto the hotplate. Avoid using griddles and earthen ware pots etc. Do not remove the wok pan support and enclose the burner with a wok stand as this will concentrate and deflect heat onto the hotplate. flame tamer, asbestos mat, between the pan and the pan support as serious damage to the cooktop may result. Use only wok support supplied or recommended by the manufacturer of the cooktop. 18 Do Always use pans that are suitable for each burner, so as avoid wasting gas and discolouring the pans. Use pans, frying pans and casserole dishes with thick flat bottoms. Installation instructions Installer instructions This appliance must be installed in a position with the proper level of ventilation. Do not obstruct the flow of combustion and ventilation air. The gas pressure regulator supplied with the appliance must be installed in line with the gas pipe. only) Before commencing any work, make sure that the power point switches are turned off and the three in plug is removed. A duplicate of this data plate is at the rear of this booklet. Observe any special conditions imposed by local suppliers (utilities). For cutout dimensions and clearances refer drawing on previous page. Slightly loosen the retaining screws of the 4 clamping brackets positioned at the bottom of the cooktop. Insert the cooktop into the bench cutout. After insertion, from below, swivel the clamp brackets 90° and tighten them against the bottom of the benchtop. Electrical connection An electrical 10 amp socket needs to be within 1 m of the hotplate to allow electrical connection. The socket must remain accessible after installation of the appliance. Important note: Ventilation requirements The use of a cooktop produces heat and moisture in the kitchen. For this reason make sure that the room is properly ventilated. Keep natural ventilation openings, such as windows, open or provide a mechanical ventilation device (e. g. Additional pan supports The wok burner is supplied with an additional pan support for pans larger than 26mm diameter, i. e. [. . . ] Use a flat bladed tool to lift the ceramic frame and remove. For replacement of wok burner refer to adjacent figure. Outer wok burner main injector conversion 1. Disassemble the wok burner pan supports and wok burner as indicated in figure at left 2. [. . . ]