User manual NEFF T29R96N0AU

[. . . ] This cooktop is for use with Natural Gas and LPG T29R8N0AU T29R96NOAU Neff GmbH Carl-Wery-Straße 34 81739 München Cod. 9000235447 C Dear customer, We would like to thank and congratulate you for your choice. This practical modern appliance has been made using materials of the highest quality, which have been put through the strictest of Quality Controls during manufacture and meticulously tested to ensure that they meet all of your cooking demands. We kindly ask you to read and follow these simple instructions in order to guarantee first-class results from the very start. [. . . ] The hose should not be subjected to abrasion, kinking or permanent deformation and should be able to be inspected along its entire length with the cooktop in the installed position. Unions compatible with the hose fittings must be used and all connections tested for gas leaks. 3 Re-assemble the burner component parts in reverse order. NOTE: it is not necessary to adjust the primary air control on these burners. 7 mm 6 7 8 11 Minimum flame adjustment. 2 Remove the control knob from the valve spindle. If your cooking hob is fitted with exterior plastic disc seals, remove them by inserting a screwdriver through the disc's central orifice and levering them out. When you have removed the disc seals from the orifice the control shaft emerges from, you will find an interior seal made of flexible rubber; you only need to press this with the tip of a screwdriver to clear the path to the tap adjusting screw. 4 The adjustment screw is positioned at the rear lower section of the valve. replace the control knob onto the spindle, light the gas and turn the control knob to the small flame position. Screw the adjustment screw anti-clockwise to estabilish a minimum stable flame position. The flame should remain alight and not burn back to the injector when the valve is turned quickcly from `Full On' to the "Minimum flame" position and back a few times. To adjust the minimum flame position for LPG the screw must be fully tightened down clockwise. 6 Replace the seals in reverse order and refit the control knob. Never dismount the valve shaft: in the event of damage, change the entire valve. 9 10 11 12 Operating instructions Burner locations 2 1 1 3 3 4 2 12 1. Control Knobs Burner ignition & control There are indications to show which burner each control knob operates. To light a burner, press the burner switch and turn it left to the maximum position, keeping it in this position for a few seconds until the burner lights before releasing and adjusting it to the required position. The corresponding on display for the burner will light up. If it does not light, the on display will flash. Turn the switch to the position and repeat the operation. If the ignition sparkers are dirty, this makes the burner harder to light, so you should keep them as clean as possible. Do this with a small brush and make sure that the ignition sparker is not hit or knocked violently. If the burners on your cooking hob are fitted with safety valves (which stop the flow of gas if one of the burners accidentally goes out), light the burners in the same way, though you should continue to hold in the control knob for a few seconds after the flame lights. [. . . ] ·The burner components have not been assembled properly. ·The gas ports on the burners are dirty. ·The burners may not be totally dry. · Check the fuse in the main fuse box and replace if faulty. [. . . ]