User manual NERO DISCSPEED 9

[. . . ] Manual Nero DiscSpeed Copyright and Trademark Information Copyright and trademark information This document, like the software described therein, is provided as a license and may only be used or reproduced in accordance with the licensing agreement. The contents of this document, as well as the associated software, is subject to change without prior notice. Nero AG rejects any responsibility for the correctness of the contents of this document and rejects any claims that transcend the clauses of the guarantee agreement. This document and all of its contents are protected by copyright and are the property of Nero AG. [. . . ] Select the value 0000MB to start the test from the beginning of the disc. Nero DiscSpeed 40 Disc Quality tab Input field End Defines the end value up to which the test should run. Nero DiscSpeed suggests a value for the disc in the drive. For a burned disc, this value may deviate from the maximum capacity, since the data may either not fill up or exceed the maximum capacity. Check box Quick Scan Check box Show C1/PIE Check box Show C2/PIF Check box Show Jitter If this box is checked, the quick scan will be run as per the settings you defined in the options under the Disc Quality navigation entry. If this box is not checked, the entire disc will be scanned. If this box is checked, the C1 errors/PI errors will be shown. If this box is not checked, this information will be hidden. If this box is checked, the C2 errors/PI failures will be shown. If this box is not checked, this information will be hidden. If this box is checked, the jitter will be shown. If this box is not checked, this information will be hidden. Not all recorders can measure jitter values. Even if this box is checked, the jitter will not be shown if the recorder in question cannot measure the values. If this check box is enabled, the read speed is displayed in the top graph. The curve is displayed in red by default. You can change this color according to your requirements in the options under the Disc quality navigation entry. If this check box is enabled, the write speed is displayed in the top graph. The curve is displayed in white by default. You can change this color according to your requirements in the options under the Disc quality navigation entry. If the Include test data check box has been enabled in the options under the Transfer Rate navigation entry, the write speed will have been recorded on the disc during the burn process and will be available for further tests on the disc. If this box was not checked during burning, the write speed cannot be displayed as the information will not have been saved on the disc. Opens the Disc Quality Test: Advanced Options dialog box. Check box Show read speed Check box Show write speed Button Advanced The Disc info area shows general information on the disc in the drive. [. . . ] 32 Running the Advanced DAE Quality Test Nero DiscSpeed 72 Index . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52 Running the quality test . . . . . . . . . . . . . . . . . . . . . . . . 43 Running the ScanDisc Test . . . . . . . . . . . . . . . . . . 46 Running the test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]