User manual NERO WAVE EDITOR 2

[. . . ] User Guide Ahead Software AG Information on copyright and trade marks The Nero Wave Editor user manual and all its contents are protected by copyright and are the property of Ahead Software. This user manual contains material that is protected by internationally valid copyright. This manual may not - in whole or in part - be copied, transmitted or otherwise reproduced without the express written permission of Ahead Software AG. All trade names and trademarks are the property of the respective owners. [. . . ] Open an audio file and highlight the section you want. In the 'Volume' menu, select the 'Fade In' or 'Fade Out' command and select the effect you require. Nero Wave Editor Audio files · 27 6 Recording gramophone records 6. 1 Preparation There are many ways of reproducing the sound of records on a computer; the following example only describes the basic procedure for doing this. The signal received from the record player's magnetic sampling system cannot be directly fed into the soundcard's line-in input, as the signal is frequencydistorted for technical reasons. A so-called 'frequency corrector preamplifier' between the sampling system and the soundcard is needed in order to correct the frequency response. This is most easily performed using the amplifier's phono input. In order to rerecord, you will need: a record player an amplifier a computer with a soundcard around 700 MB free memory cables to connect the individual components Sometimes leakage pickups (humming) can arise when the soundcard is linked to the amplifier. The humming is caused when two devices that have already been grounded (earthed) are connected with one audio cable. A by-pass power filter or transformer can solve the problem. Sometimes it is simply enough if the devices are connected to different power sources. Connect the record player to the amplifier. Clean the record. Nero Wave Editor Recording gramophone records · 28 6. 2 Recording 1. Start Nero Wave Editor: Start > programs > Ahead Nero > Nero Wave Editor. In the 'File' menu, select the 'New' command. In the 'Audio' menu, select the 'Record' command and determine the desired sampling rate and sampling resolution. To so this, click on the dropdown button and highlight the desired list box. For a recording that is to be written on a CD, a sampling rate of 44100 Hz and a sampling resolution of 16 bit are recommended. Click on the 'OK' button to take over these settings. The recording console will appear. button to start recording, then place the stylus on the record. Click on the You will see the recording time and the level control display in the recording console while you are recording. If the level is too loud or too quiet, you can change it. Open the volume control and move the slider of the 'line' section in the desired direction. At the end of a track, click on the 'OK' button to stop recording. The audio file recorded will appear in the display area. Nero Wave Editor Recording gramophone records · 29 7. [. . . ] Check the box in the 'Decrackle' area if you want to remove crackling. Specify the sensitivity of the Decrackler by turning the corresponding knobs to set the detection threshold and the crackle reduction level. Clicking on the button plays the audio file with the specified changes. This allows you to check immediately whether you are happy with the results. [. . . ]