User manual NETAFIM AQUA PRO CONTROLLER

[. . . ] Programs: P1: Once a day at the same time every day. (Factory preset 15 minutes at 06:00 A. M). P2: Once a day at the same time on selected Active days. P3: Up to three start times per day on selected days. [. . . ] utto ram roc g dig ee it n: P1 sto rt: p ual O r OF mes d. -U nce da s & n: ba w p to da ily a & Irri ttery 3 ir ily o t sa du ga rig n se me ra tio ati le tim tio n on cte e sta sp d . 1, e > ET <S E> OD <M Table of contents: Installation Controller Keyboard Controller Icons & Display Electric valve control button Battery Insertion or replacement Installation into the watering system Programming steps Set P1 Set p2 Set P3 Programming guide table Controller display in operating mode Technical information Warranty > ET <S E E> OD <M E> OD <M E> OD <M > ET > <S SET < > ET > <S SET < tiv 3, 5 eD , 7 ay , s. . 4 5 6 7 8 9 10 11 12 14 15 3 E Installation Controller Keyboard <MODE>: To select operating sequence and to enter programming. <SET>: To set program values and advance to next step. Controller Icons & Display Irrigation duration. Low battery. 4 Electric valve control buttons Auto: Close: Open: Note: If the override button (marked with a red arrow) is in Close position the AQUA PRO will remain closed. If the override button (marked with a red arrow) is in Open position the AQUA PRO will remain open. Flow Control: Flow Direction: (see page 7) E 5 Battery Insertion or replacement E Note: to operate your controller you need a high quality 9V alkaline battery (not included) The Low battery sign appears - insert or replace the battery To insert or to replace the battery: 1. Release the four screws of the battery compartment cover. Gently remove the cover, seal and screws. Take care to keep the screws and seal in a safe place. Tighten the screws. 6 Installation into the watering system 1. Install the AQUA PRO into the watering system making sure that the water flow is in the direction of the arrow on the base of the valve. You can control the flow using the Flow Control lever on the base marked from <+> to <->. E When installing the AQUA PRO, hold the valve only. 7 E Programming steps Note: Make sure that the override button (marked with a red arrow) is in the central position AUTO). Set Clock current time and day Press <MODE> for 2 seconds. If no key is pressed for more than 30 seconds during programming, the controller resumes operating mode. 8 Set P1 Once a day at the same time every day. P1 programming is completed. E 9 E Set P2 Once a day at the same time on selected Active days Note: Irrigation duration and start time has already been set at P1. To change irrigation duration and/or start time, go back to P1 (7-14) Press <MODE> three times for 2 seconds. Press <SET> to continue to day 2 18. [. . . ] This warranty does not apply where equipment is not used and installed strictly in accordance with Netafim specifications and User Manual. Neither does it apply to failures caused by lightning strikes or damage due to freezing temperatures or mechanical causes (e. g. lawnmowers) Netafim is not liable for indirect, incidental or consequential damage in connection with the use of equipment. To receive warranty benefits, customers should return defective parts to the nearest Netafim distributor. Netafim reserves the right to alter, modify or redesign its products, pricing and warranty at all times without creating any liability for the obsolescence of customer inventory of such parts or products. [. . . ]