User manual NETGEAR DG834N

[. . . ] Wireless ADSL2+ Modem Router Setup Manual NETGEAR, Inc. 4500 Great America Parkway Santa Clara, CA 95054 USA 208-10087-01 2006-4 © 2006 by NETGEAR, Inc. All rights reserved. Trademarks NETGEAR is a trademark of Netgear, Inc. Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation. [. . . ] Go to "Basic Functioning" on page 2-1. · Have I connected the router correctly?Go to "Basic Functioning" on page 2-1. · I cannot access the router's configuration with my browser. Go to "Troubleshooting the Web Configuration Interface" on page 2-3. · I have configured the router but I can't access the Internet. Go to "Troubleshooting the ISP Connection" on page 2-4. · I cannot remember the router's configuration password. Go to "Using the Reset Button" on page 2-9. · I want to clear the configuration and start over again. Go to "Restoring the Default Configuration and Password" on page 2-8. Basic Functioning After you turn on power to the router, the following sequence of events should occur: 1. When power is first applied, verify that the Power LED is on (see "The Router's Front Panel" on page 1-2 for an illustration and explanation of the LEDs). After approximately 10 seconds, verify that: a. The LAN port LEDs are lit for any local ports that are connected. The ADSL Internet port LED is lit. Troubleshooting v1. 0, 2006-4 2-1 Wireless ADSL2+ Modem Router Setup Manual If a port's LED is lit, a link has been established to the connected device. If a LAN port is connected to a 100 Mbps device, verify that the port's LED is green. If the port is 10 Mbps, the LED will be amber. If any of these conditions does not occur, refer to the appropriate following section. Power LED Not On If the Power and other LEDs are off when your router is turned on: · · Make sure that the power cord is properly connected to your router and that the power supply adapter is properly connected to a functioning power outlet. Check that you are using the power adapter supplied by NETGEAR for this product. If the error persists, you have a hardware problem and should contact technical support. Power LED is Red When the router is turned on, it performs a power-on self test. If the Power LED turns red after a few seconds or at any other time during normal operation, there is a fault within the router. The power LED also turns red when you depress the factory default reset push button, and blinks red 3 times when that button is released. However, in this case, the wireless ADSL modem router is working normally. [. . . ] In the field provided, type Ping followed by the IP address of the router, as in this example: ping 192. 168. 0. 1 3. You should see a message like this one: Pinging <IP address> with 32 bytes of data If the path is working, you see this message: Reply from < IP address >: bytes=32 time=NN ms TTL=xxx If the path is not working, you see this message: Request timed out Troubleshooting v1. 0, 2006-4 2-7 Wireless ADSL2+ Modem Router Setup Manual If the path is not functioning correctly, you could have one of the following problems: · Wrong physical connections -- Make sure the LAN port LED is on. If the LED is off, follow the instructions in "LAN or Internet Port LEDs Not On" on page 2-2. -- Check that the corresponding Link LEDs are on for your network interface card and for the hub ports (if any) that are connected to your workstation and router. [. . . ]