User manual NETGEAR FA511

[. . . ] The whole network must have the same workgroup name while each PC must have a unique name. These names can be entered by going to Start>Settings>Control Panel>Network and clicking on the Identification tab. You also need to have the Microsoft Windows Operating System CD-ROM and the GearBoxTM for Adapters CD ready to use in the installation process. 5. When Select Network Adapter box opens, click "Have Disk" then click "Next". As a last step, be sure to register your network card at http://www. NETGEAR. com. [. . . ] "NETGEAR FA511 CardBus Mobile Adapter" will appear in the model list. The next Windows appears with the following adapter name : NETGEAR FA511 CardBus Mobile Adapter. Click "Finish". Model FA511 CardBus Notebook Adapter 5. Click "Driver" and click "Update Driver" tab, then click "OK". Connect the Network Cables Using a UTP cable, connect any port on a hub or switch to the port on the network card. Note: One of the ports on NETGEAR hubs is switchable between Normal (MDI-X) and Uplink (MDI) with a Normal/Uplink push button. If you are using this switchable port on a NETGEAR hub to connect to a PC or the network card, make sure the Normal/Uplink push button is set to Normal. Remove the GearBoxTM for Adapters CD from the CD-ROM drive. The Model FA511 CardBus Adapter driver installation for Windows XP is now complete. July 2002 M 1 - F A 5 1 1 N A - 2 Install the Windows 2000 Network Driver Note: If the "Insert Disk" window opens and a message prompts you to insert your Windows CD-ROM at any time during the installation process, insert the Windows CD-ROM in Drive D (the CD-ROM drive) and click on "OK". Then follow the next step in the instructions. A Found New Hardware Wizard dialog box will appear, indicating that Windows 2000 has found the adapter. Insert the GearBoxTM for Adapters CD into your CD-ROM drive. Information is subject to change without notice. Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein. Certificate of the Manufacturer/Importer It is hereby certified that the Model FA511 CardBus Notebook Adapter has been suppressed in accordance with the conditions set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992. The operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain restrictions. Please refer to the notes in the operating instructions. Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with the regulations. VCCI Statement This equipment is in the Class B category (information equipment to be used in a residential area or an adjacent area thereto) and conforms to the standards set by the Voluntary Control Council for Interference by Data Processing Equipment and Electronic Office Machines aimed at preventing radio interference in such residential areas. When used near a radio or TV receiver, it may become the cause of radio interference. Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. [. . . ] Click "Hardware" and click "Device Manager" tab, and then double-click "Network adapters". Note: This equipment has been tested and found to comply with the Declaration of Conformity limits for a Class B digital device, pursuant to part 15 of the FCC NETGEAR Model FA511 CardBus Notebook Rules. These limits are designed to provide reasonable protection Adapter Tested to comply against harmful interference in a residential installation. This with FCC Standards equipment generates, uses, and can radiate radio frequency energy FOR HOME OR OFFICE USE and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]