User manual NETGEAR FS108P

[. . . ] Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the product described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described here in. Introduction Certificate of the Manufacturer/Importer It is hereby certified that the NETGEAR Model FS108P ProSafe 8 Port Switch with 4 Port PoE has been suppressed in accordance with the conditions set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992. The operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain restrictions. [. . . ] Operation is subject to the following two conditions: · This device may not cause harmful interference. · This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Power over Ethernet (PoE) EN 55 022 Declaration of Conformance This is to certify that the NETGEAR Model FS108P ProSafe 8 Port Switch with 4 Port PoE is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55 022 Class B (CISPR 22). Canadian Department of Communications Radio Interference Regulations This digital apparatus (NETGEAR Model FS108P ProSafe 8 Port Switch with 4 Port PoE does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications. Power over Ethernet (PoE) integrates power and data onto one single cabling infrastructure, eliminating the need to have AC power adapters available at all locations. The IEEE 802. 3af standard defines how products should provide and receive power over the data infrastructure. The FS108P complies with the 802. 3af standard. Using category 5/5e cable or better, PoE will provide power to PoE compatible device, such as IP telephones, wireless LAN access points and IP cameras, for a distance up to 100 Meters. [. . . ] Information is subject to change without notice. Support Information Phone: 1-888-NETGEAR (For US & Canada only) - 24 x7 phone support See Support Information card for other countries. E-mail: support@NETGEAR. com (24 x 7 online support) www. NETGEAR. com By registering your product at www. NETGEAR. com/register, we can provide you with faster expert technical support and timely notices of product and software upgrades. PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED WITH YOUR PRODUCT. Model FS108P ProSafe 8 Port Fast Ethernet Switch with 4 Port PoE Technical Support 201-10389-01 108 P October 2004 Installation Guide ProSafe 8 Port Switch with 4 Port PoE 10/100 Mbps FS108P [. . . ]