User manual NETGEAR FVS114 INSTALLATION GUIDE

[. . . ] If it does not turn solid green, check the adapter or the power switch. TEST: The TEST light goes on when the router is first turned on and then goes off. If after two minutes it is still on, see the Troubleshooting Tips in this guide. INTERNET: The INTERNET port LINK/ACT light should be lit. [. . . ] Disconnect the cable at the computer end only, point A in the diagram. Warning: Failure to restart your network in the correct sequence could prevent you from connecting to the Internet. First, plug in the power cord to your broadband modem, turn it on, and wait two minutes. Now, plug in the power cord to your FVS114, turn it on, and wait one minute. Note: For DSL customers, if ISP-provided software logs you in to the Internet, do not run that software. You may need to go to the Internet Explorer Tools Troubleshooting Tips Here are some tips for correcting common problems you may encounter. Technical Support Thank you for selecting NETGEAR products. After completing the Smart Wizard configuration assistant, locate the serial number on the bottom label of your product and use it to register your product at http://www. NETGEAR. com/register. Registration on the web site or over the phone is required before you can use our telephone support service. The phone numbers for worldwide regional customer support centers are on the Warranty and Support Information card that came with your product. Go to http://kbserver. netgear. com for product updates and Web support. Be sure to restart your network in this sequence: 1. Turn off and unplug the modem, turn off the FVS114, and shut down the computer. Plug in and turn on the modem, wait two minutes. Turn on the computer. Click OK to proceed. If you still cannot connect to the FVS114, verify your computer networking setup. Your computer should be set to obtain both IP and DNS server addresses automatically, which is usually so. For help with this, please see the Reference Manual or animated tutorials on the Resource CD. Follow the Smart Wizard prompts to connect to the Internet. Click Done on the Success screen and be sure to click OK at the prompt to close the screen and finish. Note: The configuration assistant only appears when the FVS114 is in its factory default state. [. . . ] Restart the network in the correct sequence. Advanced User Wizard Bypass Technically advanced users who want to bypass the Smart Wizard configuration assistant can do so by logging on to the firewall at http://www. routerlogin. net/basicsetting. htm with the user name of admin and the password of password, both in lower case letters. · Use the FVS114 status lights to verify correct operation. If the FVS114 Power light does not turn solid green within two minutes of turning the firewall on, or if the Test light does not go off, reset the firewall as described in the Reference Manual on the Resource CD. ©2005 by NETGEAR, Inc. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. [. . . ]