User manual NETGEAR FVS318V3

[. . . ] For DSL Service: You may need information such as the DSL login name/e-mail address and password in order to complete the VPN firewall setup. d. Securely insert the blue cable that came with your FVS318v3 (the Blue NETGEAR Cable in the diagram below) into a LOCAL port on the firewall such as LOCAL port 8 (point C in the diagram), and the other end into the Ethernet port of your computer (point D in the diagram). Check the FVS318v3 status lights to verify the following: · · PWR: The PWR light should turn solid green. If it does not turn solid green, check the adapter or the power switch. TEST: The TEST light goes on when the router is first turned on and then goes off. [. . . ] With the FVS318v3 in its factory default state, your browser will display the NETGEAR Smart Wizard welcome page. Note: If you do not see this page, type http://www. routerlogin. net in the browser address bar and click Enter. Warning: Failure to restart your network in the correct sequence could prevent you from connecting to the Internet. a. A First, plug in the power cord to your broadband modem, turn it on, and wait two minutes. Now, plug in the power cord to your FVS318v3, turn it on, and wait one minute. Note: For DSL customers, if ISP-provided software logs you in to the Internet, do not run that software. You may need to go to the Internet Explorer Tools b. c. Troubleshooting Tips Here are some tips for correcting common problems you may encounter. Advanced User Wizard Bypass Technically advanced users who want to bypass the Smart Wizard configuration assistant can do so by logging on to the firewall at http://www. routerlogin. net/basicsetting. htm with the user name of admin and the password of password, both in lower case letters. Be sure to restart your network in this sequence: 1. Turn off and unplug the modem, turn off the FVS318v3, and shut down the computer. Plug in and turn on the modem, wait two minutes. Turn on the FVS318v3 and wait one minute. Turn on the computer. Technical Support Thank you for selecting NETGEAR products. After completing the Smart Wizard configuration assistant, locate the serial number on the bottom label of your product and use it to register your product at http://www. NETGEAR. com/register. Registration on the web site or over the phone is required before you can use our telephone support service. The phone numbers for worldwide regional customer support centers are on the Warranty and Support Information card that came with your product. Go to http://kbserver. netgear. com for product updates and Web support. Click OK to proceed. If you still cannot connect to the FVS318v3, verify your computer networking setup. Your computer should be set to obtain both IP and DNS server addresses automatically, which is usually so. For help with this, please see the Reference Manual or animated tutorials on the Resource CD. [. . . ] To do so, open a browser and go to http://www. routerlogin. net. Then, when prompted, enter admin as the user name and password for the password both in lower case letters. Use the FVS318v3 status lights to verify correct operation. If the FVS318v3 Power light does not turn solid green within two minutes of turning the firewall on, or if the Test light does not go off, reset the firewall as described in the Reference Manual on the Resource CD. ©2005 by NETGEAR, Inc. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. [. . . ]