User manual NETGEAR GA622T INSTALLATION GUIDE

[. . . ] Turn the power off and unplug the power cord from your computer. Choose an available PCI slot (either a 32-bit or a 64-bit slot) and remove the corresponding back plate from the PC chassis. Insert the card into the PCI expansion slot. Caution: To avoid damaging any components on the card, handle it by the edges, using your thumbs to push it securely into the PCI slot. [. . . ] I will choose the driver to install. ", then click "Next". Installation Guide, Warranty & Owner Registration Card, and Support Information Card 10/100 Mbps RJ-45 connector 12. Remove the GearBoxTM for Adapters CD from the CD-ROM drive. The model GA622T Gigabit Adapter installation for Windows XP is now complete. Install the Windows 2000 Network Driver Note: If the "Insert Disk" window opens and a message prompts you to insert your Windows CD-ROM at any time during the installation process, insert the Windows CD-ROM in Drive D (the CD-ROM drive) and click on "OK". Then follow the next step in the instructions. A Found New Hardware Wizard dialog box will appear, indicating that Windows 2000 has found the adapter. Insert the GearBoxTM for Adapters CD into your CD-ROM drive. Click "Next". GA622T Copper Gigabit Ethernet Card Installation Guide · Warranty & Owner Registration Card · Support Information Card 3 INSTALL NETWORK DRIVER This section explains how to install the Network Driver in various Microsoft Windows Operating Systems. Some versions of Microsoft Windows Operating System may respond with different dialog boxes, or the dialog boxes may open in a different sequence than those shown in this guide, but should prompt you for the same information. Before you proceed with the installation steps, decide on a name for your network and for each PC. The whole network must have the same workgroup name while each PC must have a unique name. These names can be entered by going to Start>Settings>Control Panel>Network and clicking on the Identification tab. You also need to have the Microsoft Windows Operating System CD-ROM and the GearBoxTM for Adapters CD ready to use in the installation process. Please refer to README file in GearBoxTM for Adapters CD and NETGEAR support website for latest FAQ and trouble-shooting information. July 2002 M 1 - G A 6 2 2 N A - 1 2. The install hardware device drivers dialog box will appear. Select "Display a list of the known drivers for this devices so that I can choose a specific driver". The next Windows appears with the following adapter name : NETGEAR GA622T Gigabit UTP Adapter. Make sure NETGEAR GA622T Copper Gigabit Ethernet Card is highlighted, and then click "OK". 3. Double-click "NETGEAR GA622T Gigabit UTP Adapter". A message will appear describing the status of the device. © 2002 by NETGEAR, Inc. Trademarks NETGEAR® is a registered trademark of NETGEAR, INC. Microsoft®, Windows® and Windows NT® are registered trademarks of Microsoft Corporation. Other brand and product names are trademarks or registered trademarks of their respective holders. Information is subject to change without notice. [. . . ] Highlight the "Netgear GA622T Gigabit UTP Adapter" in the model list. If any previously installed GA622T Copper Gigabit Ethernet Card drivers are listed, you need to update the drivers as explained in the Reference Guide for the Model GA622T Copper Gigabit Ethernet Card. The Select Network Adapter dialog box opens. Click "Hardware" and click "Device Manager" tab, and then double-click "Network adapters". [. . . ]