User manual NETGEAR GS116

[. . . ] If you don’t have everything listed above, see the support information card for contact information. If you’re missing the support information card itself, get contact information at www. 2 Prepare to Install the Switch Decide where you want to place the switch. find a flat horizontal surface — such as a table , desk or shelf. [. . . ] €¢ • Apple G4 PC with GA311 adapter On=Link Both=1000M Blink=Act 100M 10M Make sure the power cord is properly connected to the switch. Make sure the power adapter is properly connected to a functioning power outlet. If it’s in a power strip, make sure the power strip is turned on. If the socket is controlled by a light switch, make sure the switch is in the on position. Make sure you are using the NETGEAR power adapter supplied with your switch. server with GA622T Adapter DSL modem • LOCAL 10/100M 10/100/1000 Mbps Gigabit Switch GS116 8 7 6 5 4 3 2 1 INTERNET 12VDC 1. 2A OFF ON PWR Auto Uplink 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 GS116 16-port 10/100/1000 Mbps Gigabit Switch Model FVS318 Cable/DSL ProSafe VPN Firewall The Port number light is not lit for a connected device or stays on continuously There’s a hardware connection problem. €¢ • • • Make sure the cable connectors are securely plugged in at the switch and the device. Make sure the connected device is turned on. If the Ethernet cable is connected to a NIC or other Ethernet adapter, make sure the card or adapter is installed correctly and is working. Make sure the cable is less than 328 feet (100 meters). Place the switch on a flat surface or hook onto the screws. For each device, insert one end of an Ethernet cable into the port in the device and insert the other end into one of the Ethernet ports on the switch. Connect the power adapter’s cord into the back of the switch and then plug the adapter into a power source (such as a wall socket or power strip). 9 kg (2 lbs) 0 to 40° C (32 to 104° F) 10% t0 90% relative humidity, non-condensing CE mark, Commercial FCC Part 15, Class A EN 55 022 (CISPR 22), C-Tick CE mark, Commercial UL listed (UL 1950), C-Tick Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the product described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein. Certificate of the Manufacturer/Importer It is hereby certified that the NETGEAR Model GS116 Gigabit Ethernet Switch has been suppressed in accordance with the conditions set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992. The operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain restrictions. Please refer to the notes in the operating instructions. Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with the regulations. [. . . ] Performance Specifications Frame Filter Rate: Frame Forward Rate: Network Latency: (using 64-byte packets) Address Database Size: Addressing: Queue Buffer: 14, 800 frames/sec max for 10M port / 148, 800 frames/sec max for 100M port/1, 488, 000 frames/sec for 1000M port 14, 800 frames/sec max for 10M port / 148, 800 frames/sec max for 100M port / 1, 488, 000 frames/sec max for 1000M port 100 Mbps to 100 Mbps: 40 µs max 1000 Mbps to 1000 Mbps: 10 µs max 8000 MAC addresses 48-bit MAC address 512 kilobytes per port EN 55 022 Declaration of Conformance This is to certify that the NETGEAR Model GS116 Gigabit Ethernet Switch is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. conformity is declared by the application of EN 55 022 Class A (CISPR 22). Canadian Department of Communications Radio Interference Regulations This digital apparatus (NETGEAR Model GS116 Gigabit Ethernet Switch) does not exceed the Class A limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications. Com/register, we can provide you with faster expert technical support and timely notices of product and software upgrades. [. . . ]