User manual NETGEAR MBRN3000

[. . . ] No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of NETGEAR, Inc. 0 Technical Support When you register your product at http://www. Com/register, NETGEAR can provide you with faster expert technical support and timely notices of product and software upgrades. For other countries, see your Support information card. [. . . ] Specifies the time of day to send the log. relevant when the log is sent daily or weekly. If the Weekly, Daily, or Hourly option is selected and the log fills up before the specified period, the log is automatically e-mailed to the specified e-mail address. After the log is sent, it is cleared from the router’s memory. If the router cannot e-mail the log file, the log buffer might fill up. In this case, the router overwrites the log and discards its contents. Click Apply so that your changes take effect. Running Diagnostic Utilities and Rebooting the Router The router has a diagnostics feature. You can use the Diagnostics screen to perform the following functions from the router: • Ping an IP address to test connectivity to see if you can reach a remote host. If Ping VPN is enabled, the ping packet always goes through the VPN if the VPN tunnel is enabled and working. Perform a DNS lookup to test if an Internet name resolves to an IP address to verify that the DNS server configuration is working. €¢ 40 | Chapter 4: Managing Your Network Mobile Broadband Wireless-N Router MBRN3000 • • Display the routing table to identify what other routers the router is communicating with. Reboot the router to enable new network configurations to take effect or to clear problems with the router’s network connection. From the main menu, under the Maintenance heading, select Diagnostics: • • Ping: Ping an IP address. If you need the IP address of a server on the Internet, you can do a DNS lookup to find the IP address. display: View the internal routing table. Typically, this information is used only by Technical Support. Reboot: Shut down and restart the router. €¢ • Note: If you reboot the router you will lose your connection. To access the router you will need to log in again after it has finished rebooting. • • Save: Save diagnostic information. Scan: Enabling Remote Management Using the Remote Management screen, you can allow a user or users on the Internet to configure, upgrade, and check the status of your router. [. . . ] FCC Requirements for Operation in the United States FCC Information to User This product does not contain any user serviceable components and is to be used with approved antennas only. Any product changes or modifications will invalidate all applicable regulatory certifications and approvals FCC Guidelines for Human Exposure This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. [. . . ]