User manual NETGEAR ME101

[. . . ] . 2 ME101 Default Wireless Configuration Settings . . 6 Identifying the Wireless Network Name (SSID), IP Address, and WEP Security Settings . . 6 Installing the Configuration Utility . . 7 Configuring the Bridge for Your Wireless Network . [. . . ] Note: The default security setting has WEP security disabled. Choose Programs>NETGEAR ME101 Bridge>ME101 Configuration Utility from the Start menu. If the bridge's name doesn't appear in the Bridge Name list, select Browse to have the utility search for an active bridge. Select the type of security you have set in your wireless router or access point--either 40/64 or 128 bit. If the key is determined through software, select Create with Passphrase and type the phrase in the Passphrase box. OR If you entered a key manually for your wireless router or access point, select Manual Entry and type the encryption keys that are used with the wireless router or access point. If you are through making changes, click Exit. 10 Using the Browser-based Configuration Software If you don't have access to a Windows-based computer, you may use the internal browser-based configuration software to configure the bridge. Make sure the router or access point is powered up. Power down the Ethernet-enabled computer. Connect the provided Ethernet crossover cable between the computer and the bridge. Power on the computer. Default Ethernet DC in 5V Antenna If your wireless network has an IP address other than 192. 168. 0. yyy, you'll first need to change the IP address on the bridge before making any other changes. 1. ME101 Wireless Ethernet Bridge Note the current setting and manually change the IP address of your computer to 192. 168. 0. 201. With a Macintosh computer use the Network control panel (OS X) or the TCP/IP control panel (OS 9. x). Type http://192. 168. 0. 200 as the Web address and press Return. To change the IP address for the bridge to match your wireless network, click IP Settings. Type admin as the User ID and type password as the Password. Type the correct IP address for the bridge. The first three sets of numbers (xxx. xxx. xxx. yyy) should be the same as your access point or router. The last set of numbers (. yyy) should be a set of unique numbers on your network. Restore the computer to its previous network settings. For example, if your network uses DHCP, return your computer to that setting instead of the manual setting. 11 Configuring the bridge settings: 1. Type http:// and the IP address of the bridge (the default is 192. 168. 0. 200) as the Web address in the browser and press Return. [. . . ] Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with the regulations. VCCI Statement This equipment is in the Class B category (information equipment to be used in a residential area or an adjacent area thereto) and conforms to the standards set by the Voluntary Control Council for Interference by Data Processing Equipment and Electronic Office Machines aimed at preventing radio interference in such residential areas. When used near a radio or TV receiver, it may become the cause of radio interference. Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice This device complies with part 15 of the FCC Rules. [. . . ]