User manual NETGEAR WG311V3

[. . . ] Reconnect the power cord and reboot the computer. After a short delay, the Found New Hardware Wizard displays. Note: If a Windows XP logo testing warning appears, click Continue Anyway to proceed. [. . . ] When prompted to enable the NETGEAR Smart Wireless Settings Utility, click Yes to accept this option. Installation Guide Follow these quick steps to install your WG311V3 PCI Adapter. The basic installation and configuration instructions below assume that your wireless network connection will be to an access point, and you are not using WEP security. Please refer to the Reference Manual on the 108 Mbps Wireless PCI Adapter Resource CD for detailed instructions on configuring WEP, using Ad-Hoc mode, or using advanced options. Note: The status bar at the bottom of the utility reports the speed of your connection. 108 Mbps speed is only possible when your wireless network has a 108 Mbps access point such as in the NETGEAR WGT624 108 Mbps Wireless Firewall Router. 4 Finally, verify wireless network connectivity Note: When the Windows XP wireless configuration utility is enabled, only the first two tab pages of the Netgear Smart Wireless Settings utility will appear. If you choose No, you must read the Windows XP documentation for an explanation of how to use the Windows XP wireless network configuration utility. To see the full NETGEAR utility, please refer to the Reference Manual on the 108 Mbps Wireless PCI Adapter Resource CD. Verify that your connection information matches your wireless network. Verify connectivity to the Internet or network resources. Windows XP Basic Installation 1 a. First, install the WG311V3 software Power on your desktop and log into the Windows Operating System Insert the 108 Mbps Wireless PCI Adapter Resource CD into your CD-ROM drive. b. 3 Now, configure your WG311V3system tray to open the a. Follow the InstallShield Wizard steps, and click Finish when done. If prompted to Restart the computer, choose Shut Down. Note: The status bar at the bottom of the utility reports the speed of your connection. 108 Mbps speed is only possible when your wireless network has a 108 Mbps access point such as in the NETGEAR WGT624 108 Mbps Wireless Firewall Router. the PCI Adapter 2 Next, installthe PCWG311V3 Wirelesscord. Shut down and remove its power WG311V3 Wireless PCI Adapter into an available PCI slot. Reconnect the power cord and reboot the computer. After a short delay, the Found New Hardware Wizard displays. Note: If a Windows 2000 displays a Digital Signature Not Found warning, click Yes to continue the installation. When the installation is complete, you will see the WG311V3 system tray icon on the lower right portion of the Windows task bar. 4 Finally, verify wireless network connectivity Note: You can also use the Networks tab to verify the availability of wireless networks and their SSIDs. [. . . ] Please see the Reference Manual on the 108 Mbps Wireless PCI Adapter Resource CD. Verify that your connection information matches your wireless network. Verify connectivity to the Internet or network resources. [. . . ]