User manual NETGEAR WGR614V5 INSTALLATION GUIDE

[. . . ] If the Wireless light is not lit, see the Troubleshooting Tips in this guide. Internet: The Internet port light should be lit. If not, make sure the Ethernet cable is securely attached to the router Internet port and the modem, and the modem is powered on. Green indicates your computer is communicating at 100 Mbps; amber indicates 10 Mbps. [. . . ] Note: For DSL customers, if software logs you in to the Internet, do not run that software. You may need to go to the Internet Explorer Tools menu, Internet Options, Connections tab page where you can select "Never dial a connection. " d. A b. c. Follow the Smart Wizard prompts to connect to the Internet. Enable your wireless network, click Next to proceed, then click Done to finish. Wireless Feature Network Name (SSID) WEP Security Default Setting NETGEAR Disabled Make sure the network settings of the computer are correct · Ethernet cable and wirelessly connected computers must be configured to obtain IP and DNS addresses automatically via DHCP. For help with this, please see the animated tutorials on the Resource CD or the Reference Manual Appendix C on the Resource CD. Some cable modem ISPs require you to use the MAC address of the computer registered on the account. If so, in the Router MAC Address section of the Basic Settings menu, select, "Use this Computer's MAC Address. " The router will then capture and use the MAC address of the computer that you are now using. You must be using the computer that is registered with the ISP. Restart the network in the correct sequence. Note: The router Smart Wizard configuration assistant only appears when the router is in its factory default state. After you configure the router, it will not appear again. You can always connect to the router configuration menu to change its settings. To do so, open a browser and go to http://www. routerlogin. net. Then, when prompted, enter admin as the user name and password for the password, both in lower case letters. Warning: The Network Name (SSID) is case sensitive. Entering nETgear will not work. · 2 Verify Wireless Connectivity with a wireless adapter. You are now Connect to the Internet from a computer wirelessly connected to the Internet!Important: Implement wireless security options appropriate to your needs. These settings enable basic wireless connectivity that let you can set up your wireless computers and test wireless Internet access through the router. The NETGEAR wireless router provides many wireless security options. Your wireless computer may not support all of these options. Please read the NETGEAR manual to identify the wireless security features of your router that satisfy your requirements and work with your wireless computer. [. . . ] For a non-NETGEAR wireless adapter, configure it to match these settings exactly. If you changed the default Network Name (SSID), be sure to use the correct Network Name (SSID) you set in the router. Wireless Adapter in a Notebook Computer 0560 ! 802. 11g Restrictions: European standards dictate maximum radiated transmit power of 100 mW EIRP and frequency range of 2. 400 ~ 2. 4835 GHz. In France, the equipment must be restricted to 2. 44654 ~ 2. 4835 GHz frequency range and must be restricted to indoor use. ©2004 NETGEAR, Inc. NETGEAR, the Netgear logo, Auto Uplink, ProSafe and Everybody's connecting are trademarks or registered trademarks of Netgear, Inc. [. . . ]