User manual NETGEAR WGU624 SETUP GUIDE

[. . . ] SetupGuideU. fm Page 1 Monday, October 4, 2004 1:46 PM Getting Started The NETGEAR CD provides a graphical step-bystep wizard that will assist you with setting up your router. Estimated completion time: about 20 minutes. 1 2 What do I do? Simply put the NETGEAR CD into your computer, and follow the on screen instructions. Remove the NETGEAR CD. Remove the router. What's on the CD? The NETGEAR CD contains the following: · · · · · A setup wizard A Setup Manual for your reference Tutorials Links to useful Web sites Bonus items 3 4 After the router is set up, how can I change its configuration? Simply open a browser and log in to the router at http://192. 168. 1. 1. The user name is admin and the password is password, in lower case letters. If you plan to stand the router up, attach its feet. [. . . ] Once the router is connected, always restart your network in this sequence: 1. Turn off the modem and unplug its power cord. Plug in the power cord to the modem and turn it on. Turn on the router and wait about 1 minute. Turn on the computer. 4. Click the Wireless Settings link and verify that the settings in the router match the settings in the wireless computer exactly. Go to http://kbserver. netgear. com for product updates and web support. Attention: When you configure the wireless settings of this device please make sure to select the correct country settings. Due to EU law, the country settings must be identical to the country where the device is operating. Important, due to non-harmonized frequencies in the EU, observe these 802. 11b restrictions: European standards dictate maximum radiated transmit power of 100 mW EIRP and frequency range of 2. 412 ~ 2. 472 GHz. In France, the equipment must be restricted to 2. 457 ~ 2. 472 GHz frequency range and must be restricted to indoor use. Make sure the network settings of the computer are correct. Both Ethernet cable and wirelessly connected computers must be configured to obtain IP and DNS addresses automatically via DHCP. For help with this, please see the tutorials on the CD. 0560 Check the router status lights to verify correct router operation. · The Power light should turn solid green. If after 2 minutes it is not, reset the router as described in the Setup Manual on the CD. If after completing the setup, the Wireless light does not come on, log in to the router and verify that the wireless feature is turned on. Make sure the cables are plugged in. · The router Internet status light will be lit if the Ethernet cable from the router to the modem is plugged in securely and both the modem and router are turned on. For each powered on computer connected to the router with an Ethernet cable, the corresponding LAN status light will be lit. The label on the bottom of the router identifies the number of each LAN port. · I don't have a working CD drive. Go to http://www. NETGEAR. com and download the manual for your product from the support area of the Web site. [. . . ] For example, entering nETgear for the SSID is not the same as entering NETGEAR. Use a computer connected to the router by an Ethernet cable. Log in to the router at http://192. 168. 1. 1 with the user name of admin and the password of password, both in lower case letters. August 2004 [. . . ]