User manual NETGEAR WIRELESS ADSL MODEM ROUTER

[. . . ] Wireless ADSL Modem Router Setup Manual NETGEAR, Inc. 4500 Great America Parkway Santa Clara, CA 95054 USA 208-10033-01 2006-2 © 2006 by NETGEAR, Inc. All rights reserved. Trademarks NETGEAR is a trademark of Netgear, Inc. Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation. [. . . ] · I cannot access the router's configuration with my browser. Go to "Troubleshooting the Web Configuration Interface" on page 2-3. · I have configured the router but I can't access the Internet. Go to "Troubleshooting the ISP Connection" on page 2-4. · I cannot remember the router's configuration password. Go to "Using the Reset Button" on page 2-9. · I want to clear the configuration and start over again. Go to "Restoring the Default Configuration and Password" on page 2-9. Basic Functioning After you turn on power to the router, the following sequence of events should occur: 1. When power is first applied, verify that the Power LED is on (see "The Router's Front Panel" on page 1-2 for an illustration and explanation of the LEDs). Verify that the Test LED lights within a few seconds, indicating that the self-test procedure is running. After approximately 10 seconds, verify that: a. The Test LED is not lit. Troubleshooting v1. 1, 2006-2 2-1 Wireless ADSL Modem Router Setup Manual b. The LAN port LEDs are lit for any local ports that are connected. If a port's LED is lit, a link has been established to the connected device. If a LAN port is connected to a 100 Mbps device, verify that the port's LED is green. If the port is 10 Mbps, the LED will be amber. If any of these conditions does not occur, refer to the appropriate following section. Power LED Not On If the Power and other LEDs are off when your router is turned on: · · Make sure that the power cord is properly connected to your router and that the power supply adapter is properly connected to a functioning power outlet. Check that you are using the power adapter supplied by NETGEAR for this product. If the error persists, you have a hardware problem and should contact technical support. Test LED Never Turns On or Test LED Stays On When the router is turned on, the Test LED turns on for about 10 seconds and then turns off. If the Test LED does not turn on, or if it stays on, there is a fault within the router. If you experience problems with the Test LED: · Cycle the power to see if the router recovers and the LED blinks for the correct amount of time. If all LEDs including the Test LED are still on one minute after power up: · · Cycle the power to see if the router recovers. Clear the router's configuration to factory defaults. This will set the router's IP address to 192. 168. 0. 1. [. . . ] If your computer obtains its information from the wireless ADSL modem router by DHCP, reboot the computer and verify the wireless ADSL modem router address as described in "Preparing a Computer for Network Access". Troubleshooting a TCP/IP Network Using the Ping Utility Most TCP/IP terminal devices and routers contain a ping utility that sends an echo request packet to the designated device. The device then responds with an echo reply. Troubleshooting a TCP/IP network is made very easy by using the ping utility in your computer. Testing the LAN Path to Your Router You can ping the router from your computer to verify that the LAN path to your router is set up correctly. To ping the router from a PC running Windows 95 or later: 1. [. . . ]