User manual NETGEAR WN111V1

[. . . ] NETGEAR RangeMax Next Wireless USB 2. 0 Adapter WN111 User Manual NETGEAR, Inc. 4500 Great America Parkway Santa Clara, CA 95054 USA 202-10365-01 December 2007 Technical Support Please refer to the support information card that shipped with your product. By registering your product at http://www. netgear. com/register, we can provide you with faster expert technical support and timely notices of product and software upgrades. Support Information Phone: 1-888-NETGEAR, for US & Canada only. [. . . ] On the status bar, click Join a Network. Figure 2-7 Note: Instead of clicking Join a Network on the status bar, you can also click the Networks tab on the Smart Wizard Settings screen. Select Yes, and click Next. Figure 2-8 2-7 v1. 0, December 2007 NETGEAR RangeMax Next Wireless USB 2. 0 Adapter WN111 User Manual 3. Select No (to use a PIN), and click Next. Figure 2-9 4. Generate a client security PIN for the WN111. Write down (or copy) the PIN. Figure 2-10 5. Open the Smart Wizard for the access point or router that you have selected. Select Add WPS Client from the menu of the Smart Wizard for the access point or router. Within 4 minutes of completing Step 4, enter the PIN in the box for the `Client's PIN' on the Add WPS Client page, and click Next. The Smart Wizard initiates your wireless connection. You can use the Status Bar to verify your network connection. For more information, see "Smart Wizard Status Bar" on page 1-10. Close the Smart Wizard for the access point or router. 2-8 v1. 0, December 2007 NETGEAR RangeMax Next Wireless USB 2. 0 Adapter WN111 User Manual Manually Selecting a Wireless Network During the WN111 software installation, the Smart Wizard lists the available networks. After installation you can use the Join a Network button or the Networks tab at any time to view the available networks and select the one that you want to use. Note: Make sure that you know the security settings for the network that you want to use. For example, if WEP is used then you need to know the WEP key. If you use secure networks frequently, set up profiles for each network with the wireless network and security settings. Depending on whether or not a wireless access point or router in the network supports Wi-Fi Protected Setup (WPS), the Smart Wizard presents different screens to manually configure a network. Manually Selecting a Wireless Network in a WPS Configuration To manually join a network in which a wireless access point or router supports WPS: 1. On the status bar, click Join a Network. Figure 2-11 Note: Instead of clicking Join a Network on the status bar, you can also click the Networks tab on the Smart Wizard Settings screen. Then, select a network. 2-9 v1. 0, December 2007 NETGEAR RangeMax Next Wireless USB 2. 0 Adapter WN111 User Manual 2. Select No, and click Next. Figure 2-12 3. Select a network from the drop-down list. [. . . ] Check to make sure that the access point is physically connected to the Ethernet network. Make sure that the IP addresses and the Windows networking parameters are all configured correctly. See the link to "Internet Networking and TCP/IP Addressing:" in Chapter B. Restart the cable or DSL modem, router, access point, and computer. [. . . ]