User manual NETGEAR WN203

[. . . ] ProSAFE Single Band 802. 11n Wireless Access Point WN203 Reference Manual June 2013 202-11223-01 350 East Plumeria Drive San Jose, CA 95134 USA ProSAFE Single Band 802. 11n Wireless Access Point WN203 Support Thank you for selecting NETGEAR products. After installing your device, locate the serial number on the label of your product and use it to register your product at https://my. netgear. com. You must register your product before you can use NETGEAR telephone support. NETGEAR recommends registering your product through the NETGEAR website. [. . . ] If available, read the release notes before upgrading the software. Select Maintenance > Upgrade > Firmware Upgrade. The Firmware Upgrade screen displays: 5. Click the Browse button and locate the image upgrade file (. bin file). During the upgrade process, the wireless access point automatically restarts, and the Test LED blinks amber. The upgrade process typically takes several minutes. When the Test LED turns off, wait a few more seconds before doing anything with the wireless access point. Verify that the new software file has been installed by selecting Monitoring > System. The System screen displays (see View System Information on page 92). The firmware version is shown in the Access Point Information section of the screen. Management 55 ProSAFE Single Band 802. 11n Wireless Access Point WN203 TFTP Server Upgrade Procedure To use this method, you need to have a TFTP server set up.  To use a TFTP server to upgrade the wireless access point firmware: 1. Download the new software file from the NETGEAR website and save it to your hard disk. Place the software file in your TFTP server location. If available, read the release notes before upgrading the software. Select Maintenance > Upgrade > Firmware Upgrade TFTP. The Firmware Upgrade TFTP screen displays: 5. Specify the following information: • Firmware File Name. During the upgrade process, the wireless access point automatically restarts, and the Test LED blinks amber. The upgrade process typically takes several minutes. When the Test LED turns off, wait a few more seconds before doing anything with the wireless access point. Verify that the new software file has been installed by selecting Monitoring > System. The System screen displays (see View System Information on page 92). The firmware version is shown in the Access Point Information section of the screen. Management 56 ProSAFE Single Band 802. 11n Wireless Access Point WN203 Manage the Configuration File or Reset to Factory Default The wireless access point settings are stored in the configuration file. [. . . ] This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Declaration of Conformity We, NETGEAR, Inc. , 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole responsibility that the ProSAFE Single Band 802. 11n Wireless Access Point WN203 complies with Part 15 Subpart B of FCC CFR47 Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. 125 ProSAFE Single Band 802. 11n Wireless Access Point WN203 FCC Radio Frequency Interference Warnings & Instructions This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]