User manual NETGEAR WN3500RP

[. . . ] Universal Dual Band WiFi Extender – Wallplug Edition User M anua l 350 East Plumeria Drive San Jose, CA 95134 USA October 2011 202-11049-01 v1. 0 Universal Dual Band WiFi Extender – Wallplug Edition Support Thank you for choosing NETGEAR. After installing your device, locate the serial number on the label of your product and use it to register your product at https://my. netgear. com. You must register your product before you can use NETGEAR telephone support. NETGEAR recommends registering your product through the NETGEAR web site. [. . . ] The following fields are displayed in the Status screen: • • • Hardware Version. The current firmware version of the extender. If you upgrade the firmware, this field changes. The language version running on the extender. If you upgrade the firmware, this field changes. Connection Status to Existing Network • • Name (SSID). Your extender is set up to connect to this SSID, also called the wireless name. The status of your wireless connection (connected or disconnected). Extender Network Settings 25 Universal Dual Band WiFi Extender – Desktop/Wallplug • Link Rate. The actual transmission (Tx) and receive (Rx) link rate in the current wireless connection. Extender IP Info • • • • • • MAC Address. The physical address of the extender, as seen from the local area network (LAN). Identifies the network DHCP server on the wireless network. The IP subnet mask associated with the LAN IP address of the extender. The IP address of the wireless network gateway. The IP address of the Domain Name Server (DNS) of the wireless network. Extender Wireless Settings • • • • • • Name (SSID). The name (SSID) of the wireless network. The location where the extender is operating. Configured. Show Statistics Scroll to the bottom of the Status screen, and click Show Statistics. The following screen displays: The screen shows statistics for the LAN (local), and wireless LAN (WLAN) ports. For each port, the screen displays the following: • Status. The status of the port. Extender Network Settings 26 Universal Dual Band WiFi Extender – Desktop/Wallplug • • • • • • • TxPkts. The number of packets transmitted on this port since reset or manual clear. The number of packets transmitted on this port since reset or manual clear. The number of collisions on this port since reset or manual clear. [. . . ] This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Declaration of Conformity We, NETGEAR, Inc. , 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole responsibility that the Universal Dual Band WiFi Extender – Desktop/Wallplug complies with Part 15 Subpart B of FCC CFR47 Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. FCC Radio Frequency Interference Warnings & Instructions This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]