User manual NETGEAR WN604

[. . . ] All rights reserved No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of NETGEAR, Inc. technical Support Thank you for choosing NETGEAR. To register your product, get the latest product updates, get support online, or for more information about the topics covered in this manual, visit the Support website at http://support. Com Phone (US & Canada only): 1-888-NETGEAR Phone (Other Countries): Check the list of phone numbers at http://support. [. . . ] You can use the WPS button on the side of the access point, or you can log in to the access point and use the Add WPS Client feature.  To add a client using the WPS button: 1. Press the WPS button located on the side of the access point. The WPS LED on the front of the access point flashes. The access point tries to associate with a wireless client. Follow the WPS instructions that came with it to press a WPS button. The wireless client attempts to join the wireless network. If it successfully joins, then it is automatically configured with the wireless network SSID and wireless security. σ To add a client when logged in to the access point: 1. Select either the Push Button (Recommended) button or the PIN (Personal Identification Number) button. The Push Button method is easier, while the PIN method is more secure. € The Push Button method lets you add a client with the WPS push button on the side panel of the WN604 and the push button on the client). € The PIN method requires you to enter the wireless client’s PIN, which should be displayed on the client’s utility interface. A progress bar on the Connecting to New Wireless Client screen shows the status of the wireless connection. If the wireless settings changed, you are notified. You can click OK to view the new settings: 4. If the settings have not changed, you can click the Success message to return to the Add WPS Client screen. In case of an error in completing the WPS process, refer to the online help. Restrict Wireless Access by MAC Address Access control lets you block the network access privilege of any specified stations through the access point. When you enable access control, the access point accepts only connections from clients on the selected access control list. this provides an additional layer of security. Configure Security 32 Wireless N150 Access Point WN604 Note: If you connected wirelessly to set up MAC authentication, make sure to include the MAC address of the computer you are using in the access control list. [. . . ] FCC Radio Frequency Interference Warnings & Instructions This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]