User manual NETGEAR WNDR4000

[. . . ] N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual 350 East Plumeria Drive San Jose, CA 95134 USA March 2011 202-10781-02 v1. 0 N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual ©2010 NETGEAR, Inc. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of NETGEAR, Inc. Technical Support Thank you for choosing NETGEAR. To register your product, get the latest product updates, or get support online, visit us at http://support. netgear. com. Phone (US & Canada only): 1-888-NETGEAR Phone (Other Countries): See Support information card. Trademarks NETGEAR, the NETGEAR logo, ReadyNAS, ProSafe, Smart Wizard, Auto Uplink, X-RAID2, and NeoTV are trademarks or registered trademarks of NETGEAR, Inc. [. . . ] Upon completion, the wireless router reboots. Erase Click the Erase button to reset the wireless router to its factory default settings. Erase sets the password to password, and the LAN IP address to 192. 168. 1. 1, and enables the wireless router's DHCP. View Router Status Select Maintenance > Router Status to display this screen. The Router Status screen provides status and usage information. The model of the hardware and the currently running firmware version. The currently selected language. Internet Port Settings MAC Address. The Ethernet MAC address of the DSL port. If no address is shown, the wireless router cannot connect to the Internet. Usually this is set to DHCP Client because the router obtains an IP address dynamically from the ISP. If set to None, the router uses a fixed IP address on the WAN. The IP address used as a gateway to the Internet for computers configured to use DHCP. The wireless router DNS server IP addresses. These addresses are usually obtained dynamically from the ISP. Chapter 5. Network Maintenance | 53 N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual LAN Port (Local Ports) MAC Address. The wireless router LAN port Ethernet MAC address. The wireless router LAN port IP address. If Off, the wireless router does not assign IP addresses to PCs on the LAN. If On, the wireless router does assign IP addresses to PCs on the LAN. The IP subnet mask used by the wireless router LAN. The default is 255. 255. 255. 0. Wireless Port See Wireless Settings Screen on page 29 for a more detailed description of these settings. The Wi-Fi network name (SSID) for the wireless network. The default for a or n operation is NETGEAR-5G. The default for b or g operation is NETGEAR. [. . . ] This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and the receiver. [. . . ]