User manual NETGEAR WNR2000V2

[. . . ] NETGEAR Wireless-N 300 Router WNR2000v2 User Manual NETGEAR, Inc. 350 East Plumeria Drive San Jose, CA 95134 USA 202-10485-01 January 2010 v1. 0 ©2009 by NETGEAR, Inc. All rights reserved. Product Registration, Support, and Documentation Register your product at http://www. netgear. com/register. Registration is required before you can use our telephone support service. [. . . ] Select Static Routes under Advanced in the main menu. The Static Routes screen displays. Figure 4-5 2. Click Add to expand the Static Routes screen. Figure 4-6 3. In the Route Name field, enter a name for this static route. (This is for identification purposes only. ) 4. Select the Private check box if you want to limit access to the LAN only. If Private is selected, the static route is not reported in RIP. Select the Active check box to make this route effective. Customizing Your Network Settings v1. 0, January 2010 4-11 NETGEAR Wireless-N 300 Router WNR2000v2 User Manual 6. In the Destination IP Address field, enter the IP address of the final destination. In the IP Subnet Mask field, enter the IP subnet mask for this destination. If the destination is a single host, enter 255. 255. 255. 255. In the Gateway IP Address field, enter the gateway IP address, which must be a router on the same LAN segment as the WNR2000v2 router. In the Metric field, enter a number between 1 and 15 as the metric value. This represents the number of routers between your network and the destination. Usually, a setting of 2 or 3 works, but if this is a direct connection, set it to 1. Click Apply to have the static route entered into the table. Wireless Repeating Function You can view or change wireless repeater settings for the wireless router. From the main menu of the browser interface, under Advanced, click Wireless Repeating Function to display the Wireless Repeating Function screen. Figure 4-7 Customizing Your Network Settings v1. 0, January 2010 4-12 NETGEAR Wireless-N 300 Router WNR2000v2 User Manual The wireless router allows you to control wireless client association: · Wireless Repeater. The wireless router sends all traffic from its local wireless or wired computers to a remote AP. To configure this mode, you must know the MAC address of the remote parent AP. The wireless router acts as the parent AP, bridging traffic to and from the child repeater AP, as well as handling wireless and wired local computers. To configure this mode, you must know the MAC addresses of the child repeater AP. Usually this check box is cleared so that the router is an access point for wireless computers. · · If this check box is selected, the router communicates wirelessly only with other APs whose MAC addresses are listed in this screen. [. . . ] Is your router's SSID broadcast enabled?See "Viewing Advanced Wireless Settings" on page 2-12. Is your router set to a wireless standard that is not supported by your wireless adapter?Check the Mode setting as described in "Viewing and Configuring Basic ISP Settings" on page 1-7. 7-11 v1. 0, January 2010 Troubleshooting NETGEAR Wireless-N 300 Router WNR2000v2 User Manual If your wireless network appears, but the signal strength is weak, check these conditions: · · Is your router too far from your adapter, or too close? [. . . ]