User manual NETGEAR WNR3500

[. . . ] NETGEAR RangeMaxTM Wireless-N Gigabit Router WNR3500 User Manual NETGEAR, Inc. 4500 Great America Parkway Santa Clara, CA 95054 USA 202-10305-01 March 2008 v1. 0 © 2008 by NETGEAR, Inc. All rights reserved. Product Registration, Support, and Documentation Register your product at http://www. netgear. com/register. Registration is required before you can use our telephone support service. [. . . ] A default route was created with your ISP as the gateway, and a second static route was created to your local network for all 192. 168. 1. x addresses. With this configuration, if you attempt to access a device on the 134. 177. 0. 0 network, your router forwards your request to the ISP. The ISP forwards your request to the company where you are employed, and the request is likely to be denied by the company's firewall. In this case you must define a static route, telling your router that 134. 177. 0. 0 should be accessed through the ISDN router at 192. 168. 1. 100. In this example: · The Destination IP Address and IP Subnet Mask fields specify that this static route applies to all 134. 177. x. x addresses. 4-9 v1. 0, March 2008 Customizing Your Network Settings NETGEAR RangeMaxTM Wireless-N Gigabit Router WNR3500 User Manual · · · The Gateway IP Address field specifies that all traffic for these addresses should be forwarded to the ISDN router at 192. 168. 1. 100. A Metric value of 1 will work since the ISDN router is on the LAN. Private is selected only as a precautionary security measure in case RIP is activated. Select Static Routes under Advanced in the main menu. The Static Routes screen displays. Figure 4-4 To add or edit a static route: 1. Click Add to expand the Static Routes screen. Figure 4-5 2. In the Route Name field, type a name for this static route. (This is for identification purposes only. ) 3. Select the Private check box if you want to limit access to the LAN only. If Private is selected, the static route is not reported in RIP. Select the Active check box to make this route effective. 4-10 v1. 0, March 2008 Customizing Your Network Settings NETGEAR RangeMaxTM Wireless-N Gigabit Router WNR3500 User Manual 5. Type the IP address of the final destination. Type the IP subnet mask for this destination. If the destination is a single host, type 255. 255. 255. 255. Type the gateway IP address, which must be a router on the same LAN segment as the WNR3500 router. Type a number between 1 and 15 as the metric value. This represents the number of routers between your network and the destination. Usually, a setting of 2 or 3 works, but if this is a direct connection, set it to 1. Click Apply to have the static route entered into the table. Wireless Repeating (Also Called WDS) The WNR3500 router can be used with a wireless access point (AP) to build large bridged wireless networks. [. . . ] Configure and test your wireless computer for wireless connectivity. Program the wireless adapter of your computer to have the same SSID and channel that you specified in the router, and disable encryption. Check that your computer has a wireless link and can obtain an IP address by DHCP from the router. Once your computer has basic wireless connectivity to the router, you can configure the advanced wireless security functions of the computer and router (for more information about security, see Chapter 2, "Safeguarding Your Network"). Restoring the Default Configuration and Password This section explains how to restore the factory default configuration settings, changing the router's administration password back to password. [. . . ]