User manual NEWPOL XF61002IXEL

[. . . ] 43 54 56 60 2 Guide to the appliance Guide to the appliance Miele dishwashers are available in two versions: 1. Integrated ("i") dishwashers "i"- dishwashers are designed for installation under a continuous countertop. The control panel with its accessories is included with the "i"- dishwasher in a separate package for on-site installation. The front is designed to accept a custom made panel, matching the existing kitchen cabinets. [. . . ] Your Miele dishwasher is designed to shut off the water flow and drain the machine in the rare event of a valve failure. In order for this function to be active, the door must be shut, the machine must be "ON", and the Program knob must be in the "STOP" position. Once a program has started, the sequence indicator lamps (20) show the actual program stage reached by the dishwasher. Note: When required, the water softener reactivation process is performed before the wash program. It may last several minutes and occurs in intervals. During this process only the "Softener" indicator will be on. The hardness of the water supply will dictate how often (after how many washes) the water softener needs to be reactivated. For example, with a water hardness of 21 gr/gal, reactivation will take place after every 3 programs. With a water hardness of 8 gr/gal, reactivation will only take place after 11 programs. A program can be interrupted by opening the door. If the door is then closed, the program will continue from the point it was at before the door was opened. Do not place dishes, bowls or other hollow containers in the bottom basket. Adjusting the upper basket to its lowest position will allow it to accommodate larger plates. Using "Top Solo" will also save water, detergent and energy. For example, using Top Solo with the NORMAL 55°C/130°F program uses 3. 2 gallons (12 liters) of water instead of the usual 5 gallons (19 liters). Because smaller amounts of dishware are being washed, the amount of detergent used can be reduced accordingly. "Top Solo" can be selected with all wash programs. The length of the program will appear in the time display (17) in hours and minutes. Press the "Top Solo" button (18). The "Top Solo" indicator lamp illuminates, and the program duration changes. Press the "START" button (18). The "START" indicator lamp goes out and the program starts. 31 Unloading the dishwasher Unloading the dishwasher Dishes tend to break and chip easier when they are hot. [. . . ] Existing plumbing: Do not, under any circumstances, cut the intake hose. If the hose is cut, the dishwasher will not work, you will have a water leak and you could be injured. If the hose is too long, coil it neatly and place it behind the machine. If the standard 3/8" copper plumbing for a dishwasher already exists with a compression fitting and valve as pictured: Cut the 3/8" copper tubing after the valve. Install the 3/8" compression to 3/4" MHT (Male Hose Thread) adapter (supplied with the machine), as illustrated. [. . . ]