User manual NEXT BASE MVS PRO

[. . . ] The T shaped raised slot in the middle of the mounting plate must engage with the guide(s) on the back of the portable DVD player. Note that the mirror stand has an integral latch to hold the portable DVD player securely in place. Ensure this latch is engaged by hearing it click in to place. M V S P RO Mu lti -V i sion S et PRO O per atin g I nst ruc tio ns Fitting portable DVD player to headrest mount 1. [. . . ] Caution: Please make sure that before installation, the place for the cupules should be clean and smooth. Or else the mirror stand will fall off easily. of the installation method. Note: When removing the mirror stand, pull up the two small handles first. And lift the two eared rubber on the outer side of each cupule. Then the mirror stand can be removed conveniently. Page 4 Page 5 MVS02-ENG-NB-A/1 A/1 "cupu le " "mirror " PDF "pdfFactory Pro" www. fineprint. cn MVS PRO Thanks for purchasing this multi-vision set for portable DVD player. It is designed to install the DVD player to car headrest or fix it in car for in-car using. 2. Place the backplate on the back of the player and using 4 screws provided to screw it onto the player. Turn the portable DVD player mounting plate on the centre arm vertical and to face the rear of the car. Slide the portable DVD player in place by using a vertical sliding action from the top downwards. The T shaped raised slot in the middle of the mounting plate must engage with the guide (s) on the back of the portable DVD player. note the centre arm has an integral latch to hold the portable DVD player securely in place. Ensure this latch is engaged by hearing it click in to place. Package contents 1 1 X Centre Arm 2 1 X Headrest Mount Fitting and use of the centre arm 1. Undo the thumb wheel to open up the jaws of the centre arm. See diagrams 3 1 X Mirror Stand 4 below. 8 X Screws 4. Once the portable DVD player is in position, adjust the viewing angle and screen direction for optimum pleasure by gently moving the portable DVD player in either the rotational, fwd/aft or up and down directions. The centre arm can be adjusted to the optimum length and fixed by rotating the telescopic knob. 5 1 X Arcual Backplate 6 1 X Plat Backplate The ratchet will hold the product in place at the desired position. [. . . ] Do Not remove them from the headrest mount completely. Hold the headrest mount in the middle of the headrest itself, making sure that the quick release mechanism is at the top. Pass the two top straps over the top of the headrest and down the front surface. [. . . ]