User manual NIKE TRIAX 120

[. . . ] Recorded times are accessed in DATA mode. Lap and split times are displayed simultaneously. The primary display is centrally located and larger than the secondary display, which appears below. [. . . ] Run number and date of run are displayed. NOTE: If dashes appear in the display, no data exists for that run. Check remaining memory capacity When the chronograph is reset, press the STOP/NEXT button. Lap memory capacity is displayed. Cycle by date through lap and split times, total time, best time, and average time for each run Press the START/LAP button. EN Manual FINAL (RunII) NEW 4/26/99 5:00 PM Page 10 10 c TIMER TIMER mode provides a programmable countdown interval timer. You can set up to 5 timed segments for your workout. As each timer segment is completed the next begins. Set unused segments to zero. A D J U S T /R E S E T 11 Erase data for an individual run Press the STOP/NEXT button to select a run that you want to delete. Press and hold the ADJUST/RESET button for 3 seconds. "HOLD CLEAR" flashes, and you will hear a confirmation tone, then the data for the selected run is erased. NOTE: When you delete a run the next run takes its place. For example, if you delete RUN 3 from memory, RUN 4 replaces RUN 3. If DATA memory becomes full during a run, delete that run and begin a new run. S TA R T /L A P MODE S TO P /N E XT R E P E AT N U M B E R COUNTDOWN TIMER E L E C T R O L IT E SEGMENT NUMBER Erase all data Press and hold the ADJUST/RESET button for an additional 4 seconds after deleting an individual run. "HOLD CLEAR ALL" flashes in the display. After 7 seconds, [-- --] indicates that all data has been erased. Set the timer segments 1 Press and hold the ADJUST/RESET button for two seconds. "HOLD ADJUST" flashes in the display, then the segment number and hour:minutes seconds display appears. The seconds indicator flashes. 2 Press the START/LAP button to increase the flashing value. Press once to increase the flashing value. Hold down for quick advance. EN Manual FINAL (RunII) NEW 4/26/99 5:00 PM Page 12 12 Start the countdown 1 Set any or all 5 segments. 2 Press the STOP/NEXT button to advance to the segment you want to start with. When the countdown reaches zero, the timer beeps, and the countdown begins for the next segment. The number completed timer cycles appears above the countdown display. NOTE: When the countdown is complete for all 5 segments, the cycle repeats. [. . . ] The seconds indicator flashes. NOTE: Under thirty seconds the value resets to zero. Over thirty seconds, minutes advance. 6 Repeat steps 3-5 until you have set all values: seconds, hours, minutes, day, month, year, 12 or 24-hour clock, and day/date or month/date display. 7 Press the ADJUST/RESET button to save the changes. 2 Press the START/LAP or STOP/NEXT button to reset the seconds. EN Manual FINAL (RunII) NEW 4/26/99 5:00 PM Page 22 22 g DEMO In DEMO mode you can display a brief view of functions within each mode. 23 Switch between time zones 1 In TIME mode, press and hold the STOP/NEXT button. The alternate time zone time-of-day information appears. ADJUST/RESET S TA R T / L A P MODE 2 Release the button when time zone indicator stops flashing. S TO P / N E X T 3 Follow the preceding instructions to set the time and calendar information for the alternate time zone. ELECTROLITE Hold the STOP/NEXT button for fewer than 3 seconds for a brief display of alternate time zone information. Turn the confirmation tone on and off Press the START/LAP button. [. . . ]