User manual NIKON AF NIKKOR TC 14E II TC 17E TC 20E II

[. . . ] If this lens is used with cameras not compatible with vibration reduction, set the vibration reduction ON/OFF switch ( to [OFF]. With a Pronea 600i/6i camera, in particular, battery power may become quickly depleted if this switch is left [ON]. This is a high-performance zoom lens featuring special Vibration Reduction (VR2) and high-speed Internal Focusing (IF) mechanisms. Pictures can be taken at shutter speeds approx. [. . . ] If the lens mount rubber gasket " is damaged, be sure to visit the nearest Nikon authorized dealer or service center for repair. Set your camera's focus mode selector according to this chart. Note: Be sure to set the switch so that the indicator aligns with Indicator [M/A] precisely. 2 Autofocus is provided, but you can manually override the focus M M/A by operating the separate Focus ring 8 while lightly depressing the shutter release button or the AF start (AF-ON) button on the camera. 3 To cancel manual override, again lightly depress the shutter release button or the AF start button on the camera. This will return the camera to autofocus mode. Infrared compensation With infrared film, manual compensation must be made to the focused distance. Focal length Compensation from distance index line % 70mm 100mm 135mm 200mm 300mm Shift the distance scale to the infrared compensation index $. Camera shake when taking pictures from a moving vehicle Set the vibration reduction mode switch to [NORMAL]. When taking pictures Set the vibration reduction mode switch to either [NORMAL] or [ACTIVE] When taking panning shots Set the vibration reduction mode switch to [NORMAL]. When taking pictures from a moving vehicle Set the vibration reduction mode switch to [ACTIVE]. For cameras with TTL metering, there is no need to adjust the aperture. likewise , for TTL auto flash photography with Nikon Speedlights , no adjustment is required. When using a separate exposure meter or taking photographs in the non-TTL flash mode, select the appropriate aperture value according to the focal length setting as displayed on the camera. Attaching the hood Align the lens hood attachment index ( ) 2 on the hood (either one of the two indexes) with the lens hood mounting index 4 on the lens, and turn the hood 1 clockwise until it click stops to secure. Make sure that the lens hood mounting index 4 aligns with the lens hood setting index ( ) 3. If the lens hood is not correctly attached, vignetting can occur. To facilitate attachment or removal of the hood, hold it by its base (around the lens hood attachment index) rather than its outer edge. Detaching the hood While holding the base of the hood (near the lens hood attachment index) rather than its outer edge, turn it counterclockwise to detach. Flash pictures using cameras with a built-in flash Various interchangeable focusing screens are available for certain Nikon SLR cameras to suit any picture-taking situation. The ones recommended for use with this lens are: When using screens other than type B or E, "Other screen" must be selected even when the required compensation value is "0" (no compensation required). See instruction manual of the camera body for more details. [. . . ] A lens hood 1 also helps protect the front of the lens. When storing the lens in its lens case, attach both front and rear caps. When the lens will not be used for a long time, store it in a cool, dry place to prevent mold. Do not get water on the lens or drop it in water as this will cause it to rust and malfunction. [. . . ]