User manual NIKON AF-S 70-200MM F/4G ED VR

[. . . ] € Do not look at the sun through the lens or the camera viewfinder. Viewing the sun or other bright light source through the lens or viewfinder could cause permanent visual impairment. Failure to observe this precaution could result in injury. € Observe the following precautions when handling the lens and camera: - Keep the lens and camera dry. [. . . ] – Vibration Reduction Vibration reduction reduces blur caused by camera shake, allowing shutter speeds up to five stops slower than would otherwise be the case (Nikon measurements; effects vary with the photographer and shooting conditions). This increases the range of shutter speeds available and permits hand-held, tripod-free photography in a wide range of situations. using the Vibration Reduction ON/OFF Switch Select ON to enable vibration reduction. Vibration reduction is activated when the shutter-release button is pressed halfway, reducing the effects of camera shake for improved framing and focus. select OFF to turn vibration reduction off. Using the Vibration Reduction Mode Switch The vibration reduction mode switch is used to select the vibration reduction mode when vibration reduction is on. Select NORMAL to reduce the effects of vibration when photographing from a fixed position and in other situations with comparatively little camera motion. Select ACTIVE to reduce the effects of vibration when shooting from a moving vehicle, while walking, and in other situations with active camera motion. 16 Using Vibration Reduction: Notes • Slide the vibration reduction switch to OFF if the camera does not support vibration reduction (pg. Leaving vibration reduction on may greatly increase the drain on the battery, particularly in the case of Pronea 600i/6i cameras. € When using vibration reduction, press the shutter-release button halfway and wait for the image in the viewfinder to stabilize before pressing the shutter-release button the rest of the way down. € When vibration reduction is active, the image in the viewfinder may be blurred after the shutter is released. € Slide the vibration reduction mode switch to NORMAL for panning shots. When the camera is panned, vibration reduction applies only to motion that is not part of the pan (if the camera is panned horizontally, for example, vibration reduction will be applied only to vertical shake), making it much easier to pan the camera smoothly in a wide arc. € Do not turn the camera off or remove the lens while vibration reduction is in effect. If power to the lens is cut while vibration reduction is on, the lens may rattle when shaken. This is not a malfunction, and can be corrected by reattaching the lens and turning the camera on. € If the camera is equipped with a built-in flash, vibration reduction will be disabled while the flash charges. € Turn vibration reduction off when the camera is securely mounted on a tripod, but leave it on if the tripod head is not secured or when using a monopod. En 17 ■ The Lens Hood En The lens hoods protect the lens and block stray light that would otherwise cause flare or ghosting. Align the lens hood lock mark (—¡) with the lens hood mounting mark (●) on the lens (e). When attaching or removing the hood, hold it near the symbol on its base and avoid gripping it too tightly. [. . . ] € If the lens will not be used for an extended period, store it in a cool, dry location to prevent mold and rust. Do not store in direct sunlight or with naphtha or camphor moth balls. Rusting of the internal mechanism can cause irreparable damage. € Leaving the lens in extremely hot locations could damage or warp parts made from reinforced plastic. [. . . ]