User manual NIKON EH-21 AC /BATTERY CHARGER (SUPPORTS 775, 880, 885, 995, 5000, 4300, 4500, 5400, 5700)

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Nikon Corporation may void the user's authority to operate the equipment. For USA only: Over AC 125V Use a power cord suited to the voltage in use with AC 250V AC 15A rated plugs (NEMA 6P-15) and a minimum of SVT type cord for insulation and for anything over AWG 18 in size. 1 Plug the power cable into the AC adapter. 2 Plug the power cable into a power outlet. * Shape of cable depends on country * Das mit Ihrem Ladegerät mitgelieferte Netzkabel kann von der hier gezeigten Abbildung abweichen. If the CHARGE lamp flickers red when the Nikon EN-EL1 battery is inserted, there is a problem with the battery. To ensure proper operation, read this manual thoroughly before using this product. After reading, be sure to keep it where it can be seen by all those who use the product. See the chart below for the meaning of different POWER/CHARGE lamp displays. Battery from the EH-21 battery charger, and unplug the power cable from the power outlet (Figure 3-b). The Nikon EH-21 can be used to recharge Nikon EN-EL1 rechargeable lithium-ion batteries only. Do not attempt to recharge any other batteries with the EH-21. Before use, read the warnings and other information in this manual and in the documentation for your Nikon EN-EL1 rechargeable lithium-ion battery and Nikon digital camera. Do not connect the product to any device not specifically referred to in this manual. Remove the power cable from the power outlet when not in use. Do not apply excessive force to the DC plug or cable while the AC adapter and camera are connected. [. . . ] Should this occur, remove the battery and re-insert it into the adapter to continue charging. Should an abnormality or malfunction occur, discontinue use immediately and request repairs from your retailer or Nikon Service Bureau. If the camera is connected while recharging is in progress, turning the camera on will cause the AC adapter to stop charging the battery so that it can supply power to the camera. [. . . ]