User manual NIKON LASER 500G BROCHURE

[. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Note: Please use the SCSI cable listed on Page 2 Accessories supplied with the scanner. Using other signal cables may exceed the limits of the class B Part 15 of FCC Rules. Thank you for purchasing your Nikon transparency unit. This manual describes the steps from unpacking to setting up the transparency unit and connecting it to your scanner. Please read this manual thoroughly to ensure proper operation of the unit. For an explanation of how to scan and reproduce images using the ScanTouch scanner with the transparency unit, please refer to the software manual. We hope that you find this manual helpful. The optical assembly in the transparency unit is held in place during shipment by an optical assembly slider lock. This ensures that the connector will not pull out of its port. Plug in the scanner's power cord, and turn the scanner back on. Raise the transparency unit and place a transparency on the scanner's document setting glass. Make sure that the transparency is placed within the area bordered by the green rulers. The scanner is ready to scan transparencies after launching your scanning software. Be sure to select the transparency scan type from your software to scan transparencies. Note: Before you use the transparency unit and the scanner, you need to install the application software and scanner software/ driver. To protect your transparencies from distortion, use a Slide Holder. The holder's frame provides ample area for grasping the transparency without risking damage from fingerprints and surface scratches. [. . . ] To protect your transparencies from distortion, use a Slide Holder. The holder's frame provides ample area for grasping the transparency without risking damage from fingerprints and surface scratches. Regularly cleaning the glass platten of the transparency unit will ensure that dirt or smudges will not reduce the quality of your scanned images. Before you clean the glass, make sure the scanner is turned off and the power cord is unplugged. [. . . ]