User manual NIKON MB-12

[. . . ] 10 En MB-D12 Multi-Power Battery Pack User’s Manual 1 Safety Precautions En To ensure proper operation, read this manual thoroughly before using this product. After reading, be sure to keep it where it can be seen by all those who use the product. This symbol indicates that this product is to be collected separately. The following apply only to users in European countries: • This product is designated for separate collection at an appropriate collection point. [. . . ] Make sure the holder is fully inserted before turning the latch. 4 Turn the camera on and check the battery level in the control panel or viewfinder. If the camera does not turn on, check that the battery is correctly inserted. The EP-5B Power Connector When using the EP-5B power connector, insert it into the MS-D12EN holder with the arrow (▲) on the connector toward the battery power terminals. Press the connector lightly downward and slide it in the direction of the arrow until the power terminals click into place (Figure J- q). Open the holder power connector cover and pass the EP-5B power cable through the opening (Figure J- w). Ready fully-charged spare battery or charge battery. An option in Group d of the camera Custom Settings menu can be used to change the order in which the batteries are used. When the camera is drawing power from the MB-D12, a s icon is displayed in the control panel. If the s icon blinks, the battery-chamber cover is not locked. Close and latch the battery-chamber cover. To ensure that the camera shows the correct battery level when AA batteries are used, choose the appropriate option for MB-D12 battery type in the camera Custom Settings menu (Group d). If the correct option is not selected, the camera may fail to function as expected. Option 1 LR6 (AA alkaline) 2 HR6 (AA Ni-MH) 3 FR6 (AA lithium) Battery type AA alkaline (LR6) AA Ni-MH (HR6) AA Lithium (FR6) d d (blinks) Battery Info Battery information (including calibration information for EN-EL18 batteries) can be viewed from the camera setup menu (the camera battery is listed on the left, the MB-D12 on the right). Only the battery level icon is shown when AA batteries are used. Remove the batteries when the MB-D12 is not in use. Note: The illustrations on this page are from the D800. 8 Removing Batteries Be careful not to drop batteries or the holder. 1 Turn the MB-D12 battery-chamber latch to and remove the battery holder (Figure E). En 2 Remove the battery or batteries from the holder. EN-EL15 While pressing the holder PUSH button, slide the battery toward the button. The battery can then be removed as shown. [. . . ] 9 Contatti di alimentazione (portabatterie MS-D12EN) @0 Portabatterie MS-D12 per batterie AA @1 Contatti di alimentazione (portabatterie MS-D12) @2 Coperchio vano batteria BL-5 (acquistabile separatamente) 4 MB-D12 Pulsante di scatto, multiselettore, ghiere di comando e pulsante AFON Il multi power battery pack MB-D12 è dotato di un pulsante di scatto (Figura A- !It Bloccato Sbloccato Utilizzo del battery pack Collegamento del battery pack Prima di collegare il battery pack, accertarsi che la fotocamera sia spenta e che il blocco dei comandi MB-D12 (Figura A- !2 I contatti per il multi power battery pack MB-D12 si trovano sulla base della fotocamera, dove sono protetti da un copricontatto. Rimuovere quest’ultimo come mostrato in Figura B- q e inserirlo nell’apposito alloggiamento sul multi power battery pack MB-D12 (Figura B- w). [. . . ]