User manual NIKON MB-CP11 BATTERY PACK (SUPPORTS 8800)

[. . . ] ⷠDo not short the battery pack's power terminals with a metal object such as a necklace or keys. Shorting the power terminals could result in leakage, fire, explosion, or other damage to the batteries in the battery pack. Be sure to replace the battery pack contacts cover whenever the battery pack is not in use. [. . . ] Be sure to replace the battery pack contacts cover whenever the battery pack is not in use. ⷠWhen carring the battery holder removed from the MB-CP11 BATTERY PACK (SUPPORTS 8800), remove its batteries or install it in a case to avoid possible short-circuit caused by contacts with other metal objects. Should you notice smoke or an unusual smell or noise coming from the battery pack, discontinue use immediately and take the device to your retailer or Nikon-authorized service center for inspection. 1 2 3 4 5 6 7 8 9 10 11 12 Shutter-release button for vertical-orientaiton photography Shutter-release button locking ring Holder for battery-chamber cover Signal coupling contacts Attachment wheel Zoom button Battery holder Battery holder latch Tripod socket Holder for coupling contacts cover Power terminals Battery pack contacts cover Before attaching the battery pack, be sure that the camera is off and that the shutter-release button locking ring (Figure 1on the battery pack is in the L position. Remove the battery pack contacts cover (Figure 1battery pack is not in use. Be sure to replace the battery pack contacts cover whenever the Remove the coupling contacts cover, also found on the base of the camera, by pushing it down at and sliding it out in the direction of the arrow, as shown in Figure 2A. Fully insert the coupling contacts cover into the coupling contacts cover holder on the MBE5700 as shown in Figure 2A- . Hold the battery-chamber cover at about 45°, gently pull until the peg (Figure 2B- ) pulls free and remove the cover. If you will not be using the battery pack for long periods, remove the batteries to prevent leakage. ⷠWhen replacing batteries, be sure to replace all six batteries at the same time and with new batteries of the same make and model. Never mix old and new batteries or batteries of different makes. Failure to observe this precaution could result in fire, electric shock, or in the batteries rupturing. The battery pack is equipped with shutter-release and zoom buttons for taking vertical-orientaiton photographs. The shutter-release button on the battery pack is equipped with a locking mechanism. To use the battery pack shutterrelease button, rotate the locking ring to the · (on) position. The shutter-release button locking ring on the battery pack cannot be used for turning the camera on and off. [. . . ] The shutter-release button on the battery pack is equipped with a locking mechanism. To use the battery pack shutterrelease button, rotate the locking ring to the · (on) position. The shutter-release button locking ring on the battery pack cannot be used for turning the camera on and off. [. . . ]