User manual NIKON MC-EU1 (SUPPORTS 880, 990)

[. . . ] Federal Communications Commission (FCC) Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Use the camera zoom buttons to zoom in or out, or switch to remote mode. Keep the camera's LCD monitor turned on while using the remote cord. In these modes, you can take photographs one after the other at a specified interval, which can be set in increments of one second to any value from two minutes to twenty-four hours. Interval modes A and B are only available when the camera is in recording mode, not when the camera is in playback mode. Le câble de télécommande dispose de trois modes de fonctionnement : un "mode à distance" qui sert à commander l'appareil photo à distance et deux "modes Intervallomètre" (Mode Intervalle A et Mode Intervalle B) que l'on peut utiliser lors de prises de vue automatisées. While the item is flashing, press the down button to decrease its value, or the up button to increase its value. The value displayed will change by one each time either button is pressed. After adjusting settings, press the selection button until the display is no longer flashing. Refer to the Nikon Guide to Digital Photography provided with your camera for more information on the operations performed when the shutter-release button is pressed halfway. If the interval is set to less than two minutes when the shutter-release button is half-pressed, the interval display will flash. Choose an interval of two minutes or more. Refer to the Nikon Guide to Digital Photography for more information on the operations performed when the shutter-release button is fully pressed. When the camera enters interval mode, it will either take a picture and then begin the count to the next photograph (Interval Mode A), or begin the count to the first photograph (Interval Mode B). Insert a CR2032 lithium battery oriented as shown by the "+" and "­" marks inside the battery chamber (Figure 2b) and close the battery chamber (Figure 2c). After turning the camera off, fully insert the remote cord plug into the camera's USB/serial connector. The camera may malfunction if the plug is not fully inserted. [. . . ] The action of pressing the shutter-release button to this position is called a "full press. Keep the warranty in a safe place after filling out the warranty and confirming the relevant details at the point of purchase. Should you find that the remote cord does not function as expected, please reread this manual. [. . . ]