User manual NILES 650 INSTALLATION GUIDE

[. . . ] Only when construction is completely finished do you put the valuable speaker in the wall. New Construction Wings Bracket Frame Speaker Baffle Grille Figure 1 Figure one illustrates all the components (Bracket Kit, Frame/Grille Kit and Speaker Kit) required to install a Model HD-800 Blueprint Series Loudspeaker in new construction. New Construction Installing the Wings and Bracket Attach the wings to the bracket by snapping them into the sides of the bracket. The wings can be shortened by breaking them along the scored lines if their length will interfere with a corner or eaves. [. . . ] When determining the final location of the cutout keep in mind that the frame and bracket will extend beyond the cutout. Make sure that you do not place the edge of the cutout directly next to a stud. Locate the studs using a stud sensor or hand-knocking. Once you have determined the correct position for the cutout, hold the supplied template up to the wall surface. Level the template in either the horizontal or the vertical position and mark the wall with a pencil. Drill the four corners with a 1/4" drill bit. If you are cutting a painted or wall papered wall use a sheetrock or keyhole saw. Cut the hole with the saw at a 45 degree angle. That way, the drywall section can be replaced cleanly if there is an unseen obstruction behind the wall. BE VERY CAREFUL NOT TO SAW THROUGH EXISTING WIRES, PIPES, OR STRUCTURE. [. . . ] Do not overtighten the screws, this will distort the frame and the grilles will not fit (this is not permanent, just loosen the screws and the grille will pop in). The screws should pull the frame and bracket together (sandwiching the drywall) so that the frame is absolutely flush with the wall surface. [. . . ]