Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual NILES IRC-1. We hope that this NILES IRC-1 user guide will be useful to you.
Lastmanuals help download the user guide NILES IRC-1.
Detailed instructions for use are in the User's Guide.
[. . . ] With proper placement, a single IRC-1 flasher can control an entire stack of audio /video components. · The IRC-1 is equipped with prestripped and tinned wire ends. · An adhesive-backed Velcro strip is included with the IRC-1, providing quick, secure, "remove and replace" mounting. [. . . ] Connecting Multiple Flashers
FIGURE 1 Controlling a stack of components. FIGURE 2 Controlling a tall stack of components. FIGURE 3 Controlling a stack of components by reflecting infrared commands. 7
It is possible to use more than one flasher from a single output on a Niles infrared sys8
2
3
4
5
6
Over Please
INSTALLATION & OPERATION GUIDE
tem. Consult the operating manual of the Niles main system unit or consult your local Niles dealer for more information. Increasing the Wire Length If the connecting wire is too short to reach the main system unit, a new length of heavier gauge wire should be spliced onto a six inch length of the original wire. For distances between ten and twenty feet upgrade the original wire to an eighteen gauge two-conductor wire. For distances of up to two hundred feet go to a sixteen gauge two-conductor wire.
Mounting the IRC-1 Test the operation of the IRC-1 in the planned mounting location. If all of the components operate correctly via the IR repeater system, mount the IRC-1 using it's self-adhesive Velcro strip. Make sure the mounting surface is clean and dry. Remove the protective coating from the back of the Velcro strip attached to the IRC-1 and stick it in place. Coil any excess connecting wire and tie it in place.
TROUBLESHOOTING
This troubleshooting guide discusses the most common problems that prevent an IR flasher from operating correctly.
it is farther away from the sensor window or off to the side of the sensor window. If adjusting the level down makes no change, or makes operation even worse, return the level to the full power position (clockwise). Then, try moving the
IRC-1 closer to the sensor window or try to point the L. E. D. 's more directly at the sensor window.
the Flasher Level Adjust (located on the Main System Unit) counter-clockwise. [. . . ] Reduce the flasher output until normal operation resumes. This is done by turning
12
If problems persist, refer to the user's manual for the Main System Unit or contact your local Niles dealer.
TECH TIP Wire size is expressed by its AWG (American Wire Gauge) number. The lower the number, the larger the wire, i. e. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE NILES IRC-1
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual NILES IRC-1 will begin.
