User manual NILES RSL-6 DATA SHEET

[. . . ] PRELIMINARY TECHNICAL DATA SHEET RSL-6 SPECIFICATIONS IR Range 30 feet @ 30 degrees off-axis Remote Controlled Speaker Selection System INTRODUCTION Individual ON/OFF butThe RSL-6 is a Infrared Remote tons for each pair Controlled Speaker Selection of speakers. The supplied remote ALL OFF button turns your entire control enables you to select system off. any pair, any combination of pairs, or all six pairs of speakers at once. [. . . ] Computerized Protection The brain of the RSL-6 is an eight bit modified Harvard Architecture Microcontroller. The microcontroller is programmed to remember the impedance of each of your speaker pairs and your amplifier's ideal load. It constantly monitors how many speaker pairs are playing (and which pairs), calculates the exact amount of impedance protection necessary, and provides the proper amount of protection for your amplifier. Red LED's indicate when a pair of speakers is on. 72 pre-printed room labels are included for easy identification. X-10® Powerline Control Using optional X-10 wireless remotes and controllers you can control the RSL-6 through the existing 120v AC electrical wires in your home. Optional Niles TW-523 interface module is required. Proudly Made in USA The RSL-6 is made in Miami, Florida and comes with a limited two year parts and labor warranty. B LENDING AND H IGH F IDELITY A RCHITECTURE ® CONTINUED OTHER SIDE MODEL RSL-6 Remote Controlled Speaker Selection System (continued) APPLICATION NOTES Connections If your amplifier has both "A" and "B" speaker pair outputs connect the RSL-6 to the "A" outputs. Do not connect anything to "B". This will prevent the amplifier or receiver from driving an unusually low impedance load. Using the RSL-6 with Tube-Type Amplifiers Virtually all tube amplifiers must be connected to a load at all times. If you are using the RSL-6 with a tube-type amplifier connect a 150 ohm, 5 watt resistor across the tube amplifier's output in parallel with the RSL-6. Impedance Matching Use the SPEAKER DIP switches on the rear panel of the RSL-6 to tell the Micro-controller the impedance of each speaker pair. Then, set the AMP DIP switches to your amplifier's recommended load (2, 4 or 8 ohms). [. . . ] 130 STREET MIAMI, FLORIDA 33186 TEL: (305) 238-4373 FAX: (305) 238-0185 CUSTOM ELECTRONIC DESIGN & INSTALLATION ASSOCIATION CHARTER MEMBER ©2000 Niles Audio Corporation. X-10 is a registered trademark of X-10 (USA) Inc. Note: Because Niles believes in constantly improving its products, Niles reserves the right to change product specifications without notice. [. . . ]