User manual NILFISK GR 8000

[. . . ] Please check all accessories on receipt. If any parts are missing or damaged please contact the company in which you purchased this machine, within 7 days of purchase quoting your serial number on the back of the machine. Diagram D · Wire Basket · Tubular Handle · Plastic Wing Nuts 4 · Back Wheel Assembly · Castor with Brake x2 6 English Guidance Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . We would like to take this opportunity to thank you for your purchase of the Nilfisk ALTO combined steam, detergent and vacuum cleaner. The GR8000 is manufactured in the EU to the highest quality Standards This instruction manual contains all of the necessary information to operate and maintain this machine. Please read this instruction manual carefully before you start using or carrying out any maintenance on the machine. [. . . ] Never use it on objects, which cannot resist the temperature (delicate materials, fabrics, plastics, wood etc). Where any doubt exists check carefully on a part of the material where minor marks will not matter. Do not operate the machine or carry out any maintenance out on it Unless you are trained and authorised to do so Unless you have read and thoroughly understand this instruction manual. 8 English Operating Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. Fill the cold water tank (Number 2 Diagram A) with clean cold water only. Anything other than clean cold water used in the water tank will void the manufacturers warranty. Fill the detergent bottle (Diagram B) with Nilfisk ALTO approved detergent. Unapproved detergent may be harmful or dangerous to the machine or the operator using the machine. This may cause irrepairable damage to seals and will void the manufacturers warranty. Connect the Steam Hose to the front of the machine (Number 7 Diagram A) ensuring it is pushed in all the way and the pin on the flap locks into the hole on the hose. Grease "O" rings on steam pin before connecting. To release the steam hose, lift the flap and pull. Plug the power cable into a 240 Volt supply. Inspect the electric cable before every use. If the cable becomes damaged at anytime the complete cable must be replaced by a Nilfisk ALTO approved distributor. Never touch the power cable or plug with wet hands !!Any maintenance work is being carried out 8. Switch the On/Off switch (Number 11 Diagram B) to the ON position. The Heater On light LED (Number 13 Diagram B) will illuminate. Allow approximately 10 minutes for the boiler to heat the water 10. When the Steam Ready LED (Number 14 Diagram B) illuminates the machine is ready to be used. 9 English Operating Procedure cont. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11. · The fan switch on the hose handle will release steam when pressed. · Pressing the detergent switch located on the top of the handle will activate the detergent pump. [. . . ] Wrap the power cable around the handle before storage. Weekly Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . To be carried out every week or every 50 hours of operation. As for daily maintenance plus the following: 1. Inspect the power cable for any signs of damage. If damaged do not repair, contact the supplier of this product. [. . . ]