User manual NILFISK ATTIX 125-01

[. . . ] Comply with the safety indications and prescriptions in this instruction manual. This vacuum cleaner is suitable for commercial use, in hotels, schools, hospitals, factories, shops, offices and apartment hotels for example, for hire and in any case for purposes other than normal domestic use. this vacuum cleaner is suitable for cleaning and vacuuming solid materials in indoor and outdoor environments. Always leave enough room around the vacuum cleaner to reach the controls easily. [. . . ] Plug the vacuum cleaner into a socket with a correctly installed ground contact/connection. Make sure that the vacuum cleaner is turned off. The plugs and connectors of the connection cables must be protected against splashes of water. Make sure that connections to the electrical mains and plug are correct. Use the vacuum cleaners only when the cables that connect to the electrical mains are in perfect condition (damaged cables could lead to electric shocks!Regularly check there are no signs of damage, excessive wear, cracks or ageing on the electric cable. When the vacuum cleaner is operating, do not: Crush, pull, damage or tread on the cable that connects to the electrical mains. Only disconnect the cable from the electrical mains by removing the plug (do not pull the cable). Only replace the electric power cable with one of the same type as the original: H07 RN - F. the same rule applies if an extension is used. The cable must be replaced by the manufacturer's Service Centre staff or by equivalent qualified personnel. Disconnect the vacuum cleaner from its power source before cleaning, servicing, replacing parts or converting it to another version/variant, the plug must be disconnected from the socket. Carry out only the maintenance operations described in this manual. Do not modify the vacuum cleaner in any way. Failure to comply with these instructions could jeopardize your safety. Moreover, such action would immediately make the EC declaration of conformity issued with the vacuum cleaner void. Comply with the safety regulations governing the materials for which the vacuum cleaner is used. If the version for liquids is used: Make sure the liquid level sensor is working correctly before vacuuming liquids. If foam forms, turn off the vacuum cleaner immediately and empty the container. Warning: Switch off the vacuum cleaner immediately if foam or liquid leaks out. Regularly clean the liquid level limiting device and check to make sure that there are no signs of damage. When vacuuming a mix of water and air, take care to avoid overloading the motor of the vacuum unit. [. . . ] Reassemble with care to avoid trapping your hands between the vacuum unit and the container. Use gloves that provide protection against mechanical risks (EN 388) with a level of protection CAT. Do not use the absolute filter again after having removed it from the vacuum cleaner. Reassemble with care to avoid trapping your hands between the vacuum unit and the container. [. . . ]