User manual NILFISK ATTIX 140

[. . . ] The vacuum cleaners must not be used or stored outdoors, or in damp places. Only versions with the level sensor can be used for liquids, if not, they can only be used to vacuum dry materials. If foam or liquid spills from the vacuum cleaner, switch it off immediately and check for the cause. The use of vacuum cleaner by people (including children) with limited physical and mental capacities or lacking in experience and knowledge is strictly forbidden, unless they are supervised by a person who is experienced in the use and safe handling of the machine. [. . . ] the same rule applies if an extension is used. The cable must be replaced by the manufacturer's Service Centre staff or by equivalent qualified personnel. If an extension is used, make sure it is fit for the power draw and protection degree of the vacuum cleaner. The vacuum cleaner's power socket must be protected by a differential circuit-breaker with surge current limitation, that shuts off the power supply when the current dispersed towards ground exceeds 30 mA for 30 ms or an equivalent protection circuit. Never spray water on the vacuum cleaner: such action constitutes a danger hazard for persons and could short circuit the power supply. Consult the latest edition of the European Union Directives, the Laws in the country of use and the current standards in force (UNI - CEI - EN), particularly European standard EN60335-2-69. Comply with the safety regulations governing the materials for which the vacuum cleaner is used. If the version for liquids is used: Make sure that the liquid level sensor operates correctly before vacuuming liquids. If foam forms, stop the vacuum cleaner immediately and empty the container. Warning: Switch off the vacuum cleaner immediately if foam or liquid leaks out. Regularly clean the liquid level limiting device and check to make sure that there are no signs of damage. Warning: the dirty liquid collected by the vacuum cleaner must be considered conductive. Disconnect the vacuum cleaner from its power source before cleaning, servicing, replacing parts or converting it to obtain another variant, the plug must be removed from the socket. Carry out only the maintenance operations described in this manual. Do not modify the vacuum cleaner in any way. Failure to comply with these instructions could jeopardize your safety. Moreover, such action would immediately void the EC declaration of conformity issued with the vacuum cleaner. To carry out maintenance operations which are not described in this manual contact the manufacturer's Service Centre or our sales network. Figure 4 1 2 3 4 5 Container release lever Castor lever Manual filter shaker knob Start/stop switch (normal version) Start/stop switch (version for vacuuming liquids) Lock the castor brakes before starting the vacuum cleaner (1). Turn the switch to "0" position to turn the vacuum cleaner off. version for vacuuming liquids Turn the switch (3) to "I" position to start the vacuum cleaner. Turn the switch to "0" position to turn the vacuum cleaner off. [. . . ] Fit the new filter and secure it in the cage with special clamps. Install the cover and the filter in the reverse order of removal. Dispose of the old filter according to the laws in force. Periodically clean the motor cooling fan to prevent the motor from overheating, especially if the vacuum cleaner is used in a dusty place. [. . . ]