User manual NILFISK ATTIX 8 GALLON AS-E

[. . . ] When sucking in liquids, always use a filter element or filter screen (for order number see section 9. If foam appears, stop work immediately and empty the tank. If you are using an extension cord, use only those specified by the manufacturer or higher quality ones (see section 9. This device stops the supply of electricity if the leakage current to earth exceeds 30 mA for 30 ms or it has an earth tester circuit. [. . . ] The operating voltage shown on the rating plate must correspond to the voltage of the mains power supply. Insert the power cord into a properly installed and fused socket with earthing contact. To comply with regulations, only approved dust producing tools should be connected. The maximum power consumption of the connected power tool is stated in section 9. Only ATTIX 8 GALLON AS/E: The suction hose diameter must correspond to the suction hose diameter setting: Hose Before switching the switch to position "auto"1), ensure that the power tool connected to the appliance socket is switched off. The vacuum cleaner motor starts when the connected power tool is switched on. Only ATTIX 8 GALLON AS/E: The suction hose diameter must correspond to the suction hose diameter setting: Hose When the power tool is switched off, the vacuum cleaner continues to run for a short moment so that any dust in the suction hose is conveyed to the filter bag. If the air speed in the suction hose drops to below 20 m/s, an acoustic warning is emitted for The motor speed and the suction power can be varied with the suction power control1). This allows precise adaptation of the suction power for different cleaning tasks. Only after sucking up dusts without a filter bag. Close the nozzle or suction hose opening with the palm of your hand. 1 Techniques If used correctly, additional accessories (pictures and order nos. , on fold-out page at front of these operating instructions), suction nozzles and suction hoses can enhance the cleaning action and reduce the cleaning effort. Effective cleaning is achieved if you follow just a few guidelines in combination with your own practical experience in special fields. Always remove the filter bag and check the floater before picking up liquids (see section 7. Before picking up dry substances with max. Disposal of the picked up material is then simple and hygienic. after picking up liquids , the filter element is wet. A damp filter element clogs more quickly when dry substances are picked up. For this reason the filter element should be washed and dried or replaced by a dry element before dry substances are picked up. If foam appears, stop work immediately and empty the tank. To reduce the amount of foam, use foam killer Alto Foam Stop (see section 9. [. . . ] > Impedance of power supply is too high. Make the old cleaner unusable immediately. Unplug the cleaner and cut the power cord. the cleaner contains valuable materials that should be recycled. [. . . ]