User manual NILFISK BDC1330

[. . . ] Before using the vacuum cleaner, the operators must be informed, instructed and trained on how to work it and for which substances its usage is permitted including the safe method for removing and disposing of the vacuumed material. This vacuum cleaner is suitable for commercial use, in hotels, schools, hospitals, factories, shops, offices and apartment hotels for example, for hire and in any case for purposes other than normal domestic use. This vacuum cleaner was conceived to clean and collect solid non-flammable materials indoor and outdoor. WARNING ­ This vacuum cleaner can only be used to vacuum dry materials. [. . . ] the same rule applies if an extension is used. The cable must be replaced by the manufacturer's Service Centre staff or by equivalent qualified personnel. Unpacking, moving, use and storage operate on flat , horizontal surfaces. The load-bearing capacity of the surface the vacuum cleaner is placed on must be suitable for bearing its weight. If an extension cable is used, make sure it is suitable for the power input and protection degree of the vacuum cleaner. ATEX variant: extensions, plugged in electrical devices and adapters cannot be used when the vacuum cleaner is used for flammable dust. Disconnect the vacuum cleaner from its power source before cleaning, servicing, replacing parts or converting it to obtain another version/variant, the plug must be removed from the socket. Carry out only the maintenance operations described in this manual. Do not modify the vacuum cleaner in any way. Failure to comply with these instructions could jeopardize your safety. Moreover, such action would immediately void the EC declaration of conformity issued with the vacuum cleaner. 9) switches from the green zone (3, Fig. 9) turn the vacuum cleaner off and shake the main filter by means of the knob (1, Fig. Do not shake the filter while the vacuum cleaner is on, as this could damage the filter itself. Wait before restarting the vacuum cleaner, to allow the dust to settle. Class M vacuum cleaners are supplied with a paper dust bag - code 81584000 (Fig. Class M vacuum cleaners must always be used with this paper bag installed. If the paper bag is not installed or is installed incorrectly, this could create health risks for persons exposed. These operations can only be carried out by trained and qualified personnel who must wear adequate clothing, in compliance with the laws in force. Take care not to raise dust when this operation is carried out. When maintenance or repair procedure are carried out, all the contaminated elements that cannot be properly cleaned, must be eliminated. These elements must be disposed of in sealed bags in accordance with applicable regulations and local laws on the disposal of such material. [. . . ] Allow the filtering chamber (3) to lower down and tighten the screws (2) once it has reached the tightness position. The gasket must be replaced if it is torn, cut, etc. [ NOTE ] If there is only a dust deposit on the separator (3, Fig. 19) allow the dust to drop through the central hole. [. . . ]