User manual NILFISK BR 1100S

[. . . ] This manual will help you get the most from your Nilfisk Rider Scrubber. Read it thoroughly before operating the machine. note: Bold numbers in parentheses indicate an item illustrated on pages A-4 ­ A-6. This product is intended for commercial use only. [. . . ] SERVICE NOTE: Move machine over floor drain before purging because a small amount of detergent will be dispensed in the process. To change the percentage, the detergent system must be OFF, then press and hold the Detergent ON/OFF Switch (J) for 2 seconds. The detergent indicator will flash and each press of the switch will cycle through the available percentages (3%, 2%, 1. Once the desired percentage is displayed on the screen (K9), stop and it will lock in after 5 seconds. cARTRIDGE INSTRUCTIONS: The Detergent Cartridge (29) is located behind the Side Access Panel (27). Fill the detergent cartridge with a maximum of 2. SERVICE NOTE: Remove the detergent cartridge from the detergent box prior to filling to avoid spilling detergent on the machine. It is recommended that a separate cartridge be used for each detergent you plan to use. The detergent cartridges have a white decal on them so you can write the detergent name on each cartridge to avoid mixing them up. The system should be purged of previous detergent when switching to a different detergent. When installing a new cartridge, remove the Cap (AA) and place the cartridge in the detergent box. Be sure you understand the operator controls and their functions. While on ramps or inclines, avoid sudden stops when loaded. Follow the instructions in preparing the machine for use section of this manual. While seated on the machine, adjust the seat and steering wheel to a comfortable operating position using the adjustment controls (23) and (5). To transport the machine to the work area, apply even pressure with your foot on the front of the Drive Pedal (8) to go forward or the rear of the pedal for reverse. Vary the pressure on the foot pedal to obtain the desired speed. press the Solution Switch (F) and hold for 5 seconds to pre-wet the floor. NOTE: This will help prevent scarring of the floor surface when starting to scrub with dry brushes. This must be done prior to pressing the Scrub ON Switch (D). Press the Scrub ON Switch (D) once for Regular Scrub, twice for Heavy Scrub or three times for Extreme Scrub mode. Both the solution flow and detergent (EcoFlex models) flow have 3 presets that coincide with the 3 scrub modes (see Control Panel). [. . . ] Replace the blades as a set if all 4 edges are nicked, torn or worn beyond their ability to be adjusted. 4 Reinstall the skirt housing assemblies onto the machine and adjust the blade for proper contact to the floor when the brush deck is placed in the scrub position. 1 2 3 The side skirt housing knob retainer screw studs have leveling Adjuster Collars (FF) that can be raised or lowered to compensate for blade wear. to adjust , remove the Skirt Assemblies (BB) from the scrub deck to access the Adjuster Collars (FF). [. . . ]