User manual NILFISK ER 1300

[. . . ] This manual will help you get the most from your Nilfisk Rider Scrubber. Read it thoroughly before operating the machine. Repairs, when required, should be performed by your Authorized Nilfisk Service Center, who employs factory trained service personnel, and maintains an inventory of Nilfisk original replacement parts and accessories. Call the NILFISK DEALER named below for repair parts or service. [. . . ] Engine Speed Switch (51): There are three engine speed settings that can be selected by the engine speed switch (51) on the control panel. The engine speed switch light will be off. Use only for heavy engine load situations such as heavy scrubbing on inclines. To select between Idle and Run press and release the engine speed switch. To select the Turbo speed, first set the speed to Run. Then press and hold the engine speed switch for 2 seconds. To go back to Run speed, press the switch again. The ER 1300 / 1600 has an automatic idle feature that will reduce the engine speed to idle when the foot pedal (29) has been in the neutral position for 20 seconds or more. The selected engine speed will automatically resume when the foot pedal is moved from neutral. If the engine speed switch (51) is pressed while in idle-override, the automatic idle feature will be temporarily disabled until the next time the foot pedal is moved from the neutral position. This can be useful during troubleshooting or if it is desired to let the machine run at full speed for warming up. Fill the detergent cartridge with a maximum of 2. SERVICE NOTE: Remove the detergent cartridge from the detergent box prior to filling to avoid spilling detergent on the machine. It is recommended that a separate cartridge be used for each detergent you plan to use. The detergent cartridges have a white decal on them so you can write the detergent name on each cartridge to avoid mixing them up. When installing a new cartridge, remove the Cap (A) and place the cartridge in the detergent box. install the Dry Break Cap (B) as shown. The system should be purged of previous detergent when switching to a different detergent. SERVICE NOTE: Move machine over floor drain before purging because a small amount of detergent will be dispensed in the process. Wait a few seconds for the start-up sequence to finish. 3 Press and hold the detergent switch (61) for approximately 2 seconds. Release the switch when the chemical purge icon (E) appears on the display and the indicator on the detergent switch (61) starts flashing. [. . . ] Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels. The side skirt's function is to channel the waste water to the squeegee, helping contain the water within the machines cleaning path. During normal use the blades will wear in time. NOTE: The main blades on each skirt assembly are held on with Tool-less Retainers. [. . . ]