User manual NILFISK FLOORTEC 560

[. . . ] www. nilfisk-alto. com FLOORTEC 560 B DEUTSCH FRANÇAIS ENGLISH NEDERLANDS BETRIEBSANLEITUNG MANUEL D'UTILISATION USER MANUAL GEBRUIKSAANWIJZING B 2 9 3 D 4 5 E 9 9 8 7 9 6 1 S310027 S310028 F S310025 G C 5 18 25 19 20 23 14 16 12 24 7 27 5 3 S310029 S310030 H I 4 17 8 2 6 5 J S310081 S310032 K 10 26 9 15 22 13 8 21 11 S310080 S310082 S310034 USER MANUAL ENGLISH INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 MANUAL PURPOSE AND CONTENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 TARGET . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 HOW TO KEEP THIS MANUAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] C) till the end of stroke, and then release it. The internal return spring strikes the dust filter frame and shakes it. Turn the ignition key to "I" position. ­ Electric filter-shaker (optional): press and hold the filter-shaker button (8, Fig. During this operation the main engine and all functions are automatically stopped. NOTE Repeat the filter shaking operation at least every ten minutes while using the machine (according to the area dusty conditions). NOTE When the dust filter is clogged and/or the hopper is full, the machine cannot collect dust and debris anymore. To avoid damaging the dust filter do not work on wet grounds. C) should be emptied after each working period and whenever is full. NOTE When the hopper is full the machine cannot collect dust and debris anymore. 2. 3. 5. Stopping the machine Release the selector lever (4, Fig. To stop the machine, turn the key (2, Fig. C), lift the handle (12) (without turning it) and engage its retainer (2). 146 2590 000(1)2005-03 A FLOORTEC 560 B 7 ENGLISH USER MANUAL HOPPER EMPTYING 1. C) pull out the hopper (17) and empty it. Take back the hopper to its normal position and engage the hook (18). The machine is ready to start working again. MAINTENANCE The lifespan of the machine and its operating safety are ensured by correct and regular maintenance. The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be defined by the person in charge of the maintenance. Operations to be carried out with the machine off, the ignition key not inserted and (if required) the battery disconnected. Moreover, carefully read the instructions in the Safety chapter. All scheduled or extraordinary maintenance operations must be performed by qualified personnel, or by an authorised Service Center. This manual describes only the easier and most common maintenance procedures. NOTE For other service procedures of the scheduled maintenance, please refer to the Service Centers. AFTER USING THE MACHINE After working, before leaving the machine: 1. [. . . ] Before scrapping the machine, remove the following components: ­ Battery ­ Polyester dust filter ­ Main and side brooms ­ Electronic board CAUTION!The removed components must be disposed of properly according to the Law in force. TROUBLESHOOTING TROUBLE REMEDY Check the battery connector (3, Fig. When the key is to "I" position the machine does not start. Check that the hood is correctly closed. [. . . ]