User manual NILFISK FLOORTEC R 680

[. . . ] The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. The purpose of this Manual is to provide the operator with all necessary information to use the machine properly in a safe and autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal. Before performing any procedure on the machine, the operators and qualified technicians must read this Manual carefully. [. . . ] While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned). NOTE This procedure can also be performed when the machine is moving. When the dust filter is clogged and/or the hopper is full, the machine cannot collect dust and debris anymore. The hopper (4) should be dumped after each working period and whenever it is full (see the procedure in the next paragraph). The engine is equipped with a warning system to prevent damages to the engine itself in case the oil quantity in the carter is insufficient. Before the oil level goes below the safety limit, the warning system automatically stops the engine. Always empty the hopper when the engine is running. Do not dump the hopper with the engine turned off, otherwise the battery discharges. To empty it, move the machine close to the dustbin and proceed as follows: · Turn off the vacuum system with the switch (66). Always perform this procedure on a level floor to avoid machine unbalance. When lifting and emptying the hopper (4), engage the parking brake with the pedal (82) and the lever (75). Keep people away from the machine and from the hopper (4) especially. 2) can be dumped only when lifted at a minimum height of 270 mm. To lower the hopper, press the hopper enabling switch (61) while pressing the hopper lowering switch (67). The hopper cannot be lowered if it is not brought to horizontal position first. After working, before leaving the machine: ­ Turn on the filter shaker shortly, by pressing the upper part of the switch (66). ­ Turn off the machine by turning the ignition key (69) to "0", then remove it. ­ Engage the parking brake by pressing the pedal (82), then engage the brake lock control lever (75). To easily push/tow the machine when it is off, proceed as follows: ­ Turn off the machine by turning the ignition key (69) to "0". ­ Open the hood (23) and fasten it with the support rod (55). ­ Remove the support rod (55) and close the hood (23). If necessary, adjust the working light beam aiming (9) with the screws (21). [. . . ] Turn the ignition key (69) to "0". Remove the screws (48), then disengage the fasteners (49) to remove the left side bulkhead (47). Clean the engine cooling system (D), as shown in the Petrol Engine Manual. Turn the ignition key (69) to "0". [. . . ]