User manual NILFISK GD 5 BACK

[. . . ] This is to avoid creating a short-cut through the dust remaining in the nozzles and tubes. The machine must not be used for picking up combustible or explosive materials, nor should it be used in an explosive atmosphere. Under no circumstances should the machine be used for picking up hot material. In particular the machine must not be used for cleaning open and closed fireplaces, ovens or similar that contain warm ashes. [. . . ] the size and quality of the dust bag and filters affect the machine efficiency. Use of non original dust bags or non original filters can cause restricted air flow which may lead to machine overload. Instead, it should be handed in to a collection point for the recycling of electrical and electronic components. By ensuring the product is treated in the correct manner, you will help prevent any negative impact on the environment and health that might arise were the product to be discarded as ordinary refuse. For further information about recycling, you should contact your local authorities, refuse collection service or the sales outlet where you bought the goods. This appliance conforms with EC Directive 89/336/EEC, 16. This appliance is not to be used by children or persons EEC, 73/23/EEC, 93/68/EEC with reduced physical, sen-sory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. Children must be supervised not to play with the appliance. General overview of equipment: Accessories shown in the illustrations may vary from model to model. Hose connection: Fit the hose inlet sleeve into the opening on the upper lid. Apply soft pressure and turn the inlet sleeve approximately half a turn to ensure it is firmly secured. Turn clockwise to lock, anti-clockwise to release. Adjustment of strap position on support plate: On the primary strap, the position of the strap can be adjusted for your individual comfort by moving the adjustment plate to the inner or outer position. Adjustment of tension ties on the strap's support plate: You can adjust the tension ties for your individual comfort. Form a loop with your finger, then move the tie through the clip forwards or backwards to the required length. Put your arms through the shoulder straps. Adjust the straps vertically by pulling down on both straps as shown in the picture. Cord set: The electric cable can be held in place on the belt by snapping the nylon tie around the coiled-up mains supply cable. Check the bag frequently to make sure that you don't overfill. Take hold of the cardboard part of the dust bag and carefully lift the bag out of the container. [. . . ] Release the two latches on the motor top. Power outlet for the Electro Nozzle is only available on some variants. Connection of bent end and handle grip: Push the handle grip into the bent end until it is properly fitted. The length can be adjusted by holding in the button and simultaneously pulling or pushing the tube components until the properly length is found. [. . . ]