User manual NILFISK GWD 220

[. . . ] Such information must be communicated to your Employees and other potential users of this equipment. Nilfisk-Advance America Inc. 300 Technology Drive Malvern, PA 19355 Tel: 1. 610. 647. 6420 Fax: 1. 610. 647. 6427 www. pa. nilfisk-advance. com e-mail: email@nilfisk-advance. com Machine Configuration Standard Configuration (Figure A, below) The GWD120 and 220 model vacuum cleaners are configured for wet/dry collection. The machines are equipped from the factory with a standard float basket (1) that is designed to shut off the flow of air when the liquid in the tank reaches the maximum level. The machines are also equipped with a main filter (2). [. . . ] Remove the float basket and inspect the condition of the foam motor gasket underneath. If gasket is dirty or damaged, replace it. Installation / Removal of HEPA Filter EMPTYING: If this vacuum cleaner is used to collect hazardous material, do not attempt to open or empty its contents without personal protective clothing and respiratory protection. This procedure must be completed in a contained environment. Contact with the cleaner, filters and all other accessories used when picking-up hazardous materials must be handled according to federal (EPA, OSHA), state and local regulations valid for the vacuumed substance. Before installing the optional HEPA filter, make sure the float basket has been removed from the underside of the motor head. Align the arrow on the HEPA filter with the arrow on the motor head as shown above. Twist the HEPA filter clockwise until it locks into place. To remove the HEPA filter, twist the filter counterclockwise until it unlocks from the motor head. Remove the HEPA filter and inspect the condition of the foam motor gasket underneath. If gasket is dirty or damaged, replace it. Assembly and Operation of Machine (continued) NOTE: Unplug the machine before servicing, emptying or assembling. Connect the suction hose to the tank by pushing the hose coupling directly into the machine's inlet. To remove the hose, press the release button at the top of the inlet and pull the hose straight out. Slide one of the extension tubes over the hose handle and slide the other tube over the end of the first tube. Select the appropriate insert for the floor tool and lock the insert in place using the red sliding tabs on top of the floor tool. Plug the extension tube into the neck of the floor tool and press the assembly together. The height of the machine's handle is adjustable. Loosen the locking screws on each side of the handle and adjust height to the desired position. Tighten the screws to secure the handle in place. Make sure the power switch(es) are off (indicated by position "0") before connecting the machine to its power source. Plug the power cord into a suitable electrical outlet. Turn the machine ON by pressing the power switch(es) to the position marked "I". Wet Pick up This machine is equipped with a float that shuts off the airflow through the machine when the maximum liquid level is reached. A noticeable change in sound level will occur when the float has actuated. [. . . ] Equipment shall not be returned without advance notice to, and consent of the Nilfisk companies. EXCEPT AS SPECIFICALLY SET FORTH HEREIN, THE NILFISK COMPANIES MAKE NO WARRANTIES, EITHER EXPRESSED OR IMPLIED AS TO ANY MATTER WHATSOEVER, INCLUDING WITHOUT LIMITATION ANY AND ALL WARRANTIES OF MERCHANTABILITY, FITNESS FOR PURPOSE, OR OTHER WARRANTIES, ALL OF WHICH ARE EXPRESSLY DISCLAIMED AND EXCLUDED. NEITHER PARTY SHALL BE LIABLE TO THE OTHER FOR SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OF PRODUCTION, LOSS OF TIME, LOSS OF PROFITS OR OTHER SIMILAR INDIRECT LOSSES WHICH MIGHT OCCUR AS A RESULT OF DEFECTS, PARTIAL OR TOTAL FAILURE OF THE PRODUCT TO PERFORM AS SPECIFIED. Correction of non-conformities or defects in the manner and for the period of time provided above, shall constitute fulfillment of all liabilities of the Nilfisk companies to the customer, whether based on contract, negligence or otherwise with respect to, or arising out of such equipment. [. . . ]